J1 | archivolt · cantilever arms

J1 | archivolt · FDQWLOHYHUDUPV
Installation Guide
INSTALL
RUN POWER
THROUGH
EITHER ARM
1. CONDUCTORS WILL BE EXTENDING FROM ONE ARM. IF THE OTHER
ARM IS DESIRED, REMOVE TRAY (SEE BELOW) AND MOVE CONDUCTORS TO
THE OTHER ARM.
2. CONNECT TO POWER WITHIN J-BOX.
3. FASTEN J-BOX COVER PLATE TO 3” OR 4” OCTAGONAL J-BOX.
4. USE PROVIDED SCREWS TO FASTEN FIXTURE TO J-BOX COVER PLATES.
5. FOR NON-POWER ARM: DUMMY J-BOX OR STRUCTURAL BLOCKING
CAN BE USED TO SUPP0RT ARM.
SERVICE
MILLED ALUMINUM
FIXTURE PLATE
WELDED TO ARM
J-BOX COVER
PLATE
TO REMOVE GEAR TRAY / REPLACE DRIVER:
1. REMOVE LENS USING SUCTION CUP (PRO7IDED)
2.REMOVE RED AND BLACK LEADS FROM LED BOARDS (SMALL FLATHEAD)
2. REMOVE REFLEC50R (PHILLIPS HEAD)
3. REMOVE GEAR TRAY (#10 HEX)
#10 HEX
HEAD SCREW
3” or 4”
OCTAGONAL J-BOX
LENS
REFLECTOR
DISCLAIMER: Installation by licensed electrical
contractor only. Contact a·light with questions.
3728 maritime way oceanside, ca 92056
ph. 760.727.7675
a·light | © RFW2014
J1 | archivolt · FDQWLOHYHUDUPV
Installation Guide
'03.6-5*1-&4&$5*0/'*9563&4
1. REMOVE END OF MOUNTING ARM (#8 ALLEN WRENCH)
ENDCAP
EXTENSION
2. NEST ROUNDED ENDCAP EXTENSION INTO SOCKET OF
MOUNTING ARM.
SET SCREWS
3. REPLACE MOUNTING ARM END.
4. USE SET SCREWS ON TOP OF MOU/TING ARM TO LOCK
DESIRED FIXTURE POSITION.
MOUNTING
ARM END
5. WIRING MAY BE PASSED THROUGH ENDCAP EXTENSION
TO POWER ADJOINING FIXTURE SECTION
/05&3&'&350'"$503:%3"8*/(4'03.06/5*/("3.41"$*/(
DISCLAIMER: Installation by licensed electrical
contractor only. Contact a·light with questions.
3728 maritime way oceanside, ca 92056
ph. 760.727.7675
a·light | © RFW 2014
Download PDF