DATA SHEET
WIRING
.
Smart Vision Lights cables are 5 conductors M12 in 18AWG wire. 18AWG is recommended for
ALL OverDrive series and standard series lights. 18AWG is necessary to strobe lights at full
current. Common M12 cables are 22AWG. Standard 22 AWG wires will not supply full power
needed for our light. Smart Vision Lights recommends the cable from the power supply to the
light be kept to a minimum.
PIN
Wire Color
Function
Signal
1
2
3
4
5
BROWN
WHITE
BLUE
BLACK
GREEN
Power
NPN Strobe
Ground
PNP Strobe
Analog Intensity Control
+24 VDC
GND for Active ON
GND
4VDC to 30VDC for Active ON
0-10 VDC
Standard M12 5 Pin cable color code
Pin and Cable Color Assignment
Connector on Light
1 = 24VDC
2 = NPN STROBE
3 = GND
4 = PNP STROBE
5 = 0-10VDC Analog
Standard M12 mating cable color
BROWN
WHITE
BLUE
BLACK
GREEN (GRAY)
If Analog 0-10 VDC is not used to control light intensity; +VDC (24VDC) must be connected to Analog Input.
•
5 pin Standard M12 mating cable must be used.
•
0 – 10 VDC Analog controls intensity of light from 10-100%. 0VDC = 10%, 10VDC = 100%
•
PNP and NPN strobe – In strobe mode the light output will track the pulse width of the strobe input.
•
Continuous mode – Leaving the NPN or PNP strobe signal in an active ON state. Non-OverDrive Lights.
Smart
Vision
Lights
· 2359
Holton
Road D· 353
Muskegon,
MI 49445
· Phone
231.722.1199
Smart
Vision
Lights
• 1887
Holton
Rd. • Suite
• Muskegon,
MI 49445
• Phone
231.722.1199
www.smartvisionlights.com
Download PDF