Update iP OS - Weintek.com

How to Update iP Series HMI OS Image
FAQ
Q.
How to update iP Series HMI OS image?
To update iP Series HMI OS image, save the OS file in a USB drive and then
insert the USB drive into the HMI. This FAQ explains how to check OS version
and use USB drive to update OS image.
A.
Checking OS version:
Step 1. On the system setting bar in the lower-right corner of the screen,
press
and then press
to view the system information.
Step 2. Open [Version] tab to check the OS version.
www.weintek.com
How to Update iP Series HMI OS Image
FAQ
Updating OS version:
Step 1. Copy the “firmware_ip.bin” file into USB drive directory.
Step 2. Insert the USB drive into iP Series HMI. When the “download/upload”
dialog box is displayed, press [cancel] to close it.
Step 3. On the system setting bar in the lower-right corner of the screen,
press
and then press
to open system settings dialog box.
Step 4. Enter HMI password, the default password is “111111”.
Step 5. Open [Firmware setting] tab and press [Upgrade firmware].
Step 6. When the [Pick a Directory] dialog box pops up, select the folder that
saves the OS file.
Step 7. The system will ask whether to continue firmware upgrade, press [Yes]
to start upgrading.
www.weintek.com
How to Update iP Series HMI OS Image
FAQ
Step 8. The system will start progressing upgrade and this may take a little
while, please keep the power supply during this process.
Step 9. When finish upgrading, the system will restart HMI. After this,
touchscreen calibration is highly recommended.
Touchscreen Calibration:
Step 1. Press and hold the screen lightly with your finger and then power up
the HMI.
Step 2. After the starting process, the system directly enters calibration
mode.
Step 3. Touch the center of all the “+” signs on the screen with your finger or
a stylus. The signs disappear if correctly touched, and the touch
parameters are stored in the system.
www.weintek.com
Download PDF