Installation Guide Smart-UPS™ C
Rack-Mount 2U
1000/1500 VA 120/230 Vac
Important Safety Messages
Read the instructions carefully to become familiar with the equipment before trying to install, operate, service
or maintain it. The following special messages may appear throughout this manual or on the equipment to
warn of potential hazards or to call attention to information that clarifies or simplifies a procedure.
The addition of this symbol to a Caution product safety label indicates that a hazard exists that can
result in injury and product damage if the instructions are not followed.
The following safety messages may appear throughout this manual to warn of potential hazards
CAUTION
CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage and minor or
moderate injury.
CAUTION
CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage.
Safety and General Information
Inspect the package contents upon receipt. Notify the carrier and dealer if there is any
damage.
Read the Safety Guide supplied with this unit before installing the UPS.
• Adhere to all local and national electrical codes.
• This UPS is intended for indoor use only.
• Do not operate this UPS in direct sunlight, in contact with fluids, or where there is excessive
dust or humidity.
• Be sure the air vents on the UPS are not blocked. Allow adequate space for proper ventilation.
• The battery typically lasts for two to five years. Environmental factors impact battery life.
Elevated ambient temperatures, poor quality utility power, and frequent short duration
discharges will shorten battery life.
• Connect the UPS power cable directly to a wall outlet. Do not use surge protectors or
extension cords.
• The batteries are heavy. Remove the batteries prior to installing the UPS in a rack.
• Refer to Specifications in the Operation manual for UPS and battery weight.
Inventory
All models
1000/1500 VA
230 Vac models
(4)
(2)
(2)
(2)
(1)
(1)
Documentation CD
(1)
PowerChute Software
CD
(2)
(2)
(1)
(2)
(4)
Product Overview
Rear panel features
su0644d
1000 VA 230 Vac models
su0644c
1000 VA 120 Vac models
1500 VA 120 Vac models
su0644e
su0644b
1500 VA 230 Vac models
4 Outlets
5 USB port
6 Serial data port
1 UPS input
2 Circuit breaker/Overload protection
3 Chassis ground screw
Front panel features
1 On line/On Battery LED
2 POWER ON/OFF button
3 120 Vac models only:
su0740a
Site Wiring Fault/System Fault LED
4 Display interface
5 DISPLAY button
6 MUTE button
2
Smart-UPS C 1000/1500 VA 120/230 Vac Rack-Mount 2U
Installation
CAUTION
DAMAGE TO EQUIPMENT OR PERSONNEL
• The equipment is heavy. Always practice safe lifting techniques adequate for the weight of the equipment.
• The combined weight of the UPS and the battery is heavy. Remove the battery before installing the UPS in a rack.
Failure to follow these instructions can result in equipment damage and minor or moderate injury
CAUTION
DAMAGE TO EQUIPMENT
• When installing equipment in a rack, always install peripheral equipment at the bottom of the rack.
• The UPS should always be installed above peripheral equipment in rack or stack configurations.
Failure to follow these instructions can result in equipment damage
1000 VA 120/230 Vac models
1
2
s u06
s u06
48c
3
49c
4
su06
s u 04
5 1c
Two post rack installation
1
40c
2
s u0 4
69f
su0469g
Four post rack installation
3
4
su0750b
Smart-UPS C 1000/1500 VA 120/230 Vac Rack-Mount 2U
3
bu059a
Install the battery
s u0 6
Secure the battery compartment door
29d
Install the bezel
s u06
1500 VA 120/230 Vac models
1
su 05
59c
63b
2
s u0 6
su0 6
6 1c
57c
3
1
s u 04
40c
Two post rack installation
s u0 4
69f
su0469g
Four post rack installation
su0750b
4
Smart-UPS C 1000/1500 VA 120/230 Vac Rack-Mount 2U
Connect the battery
s u 06
su0631c
Install the battery
29e
Secure the battery compartment door
Install the bezel
s u0 6
su06
58c
30d
Connect equipment to the UPS and connect the UPS to utility power
CAUTION
RISK OF EQUIPMENT DAMAGE
• Adhere to all local and national electrical codes.
• Wiring should be performed by qualified electrician.
• Always connect the UPS to a grounded outlet.
su0628b
Failure to follow these instructions can result in equipment damage
Smart-UPS C 1000/1500 VA 120/230 Vac Rack-Mount 2U
5
Select models are ENERGY STAR® qualified.
For more information go to www.apc.com/site/recycle/index.cfm/energy-efficiency/energy-star/
© 2013 APC by Schneider Electric. APC, the APC logo, Smart-UPS and PowerChute are owned
by Schneider Electric Industries S.A.S., or their affiliated companies. All other trademarks are
property of their respective owners.
EN 990-4495D-002
03/2013
Download PDF