- No category
advertisement
Available from www.dpcav.com
Part Number AWM682RX-OEM
Doc No :
AWM682RX 5.8GHz Wideband FM Receiver Module
Page 1 of 9 Rev 0
AWM682 RX
5.8 GHz Wideband FM Receiver
AIRWAVE TECHNOLOGIES INC.
Copyright 2008 by Airwave Technologies Inc. All Specification are subject to change without notice.
Doc No :
Revision History
Version
1
Item
Initial version.
Design Kit – 5.8GHz Wideband FM Receiver Module
Change Reason Date
08/14/2008
AIRWAVE TECHNOLOGIES INC. www.airwave.com.tw
Copyright 2008 by Airwave Technologies Inc. All Specification are subject to change without notice.
Doc No :
Design Kit – 5.8GHz Wideband FM Receiver Module
Contents
1. Descriptions 4
2. Feature 4
3. Application 4
4. Function block 5
5. Pin define 5
6. Pin descriptions 6
7. Absolute maximum ratings 6
8. DC/AC Electrical characteristic 7
9. Reference circuit 8
10. Dimension 9
AIRWAVE TECHNOLOGIES INC. www.airwave.com.tw
Copyright 2008 by Airwave Technologies Inc. All Specification are subject to change without notice.
Doc No :
Design Kit – 5.8GHz Wideband FM Receiver Module
1. Descriptions:
The Airwave AWM682RX 5.8GHz Audio/Video wireless RF receiver module uses the popular 5.8GHz ISM band. Designed with high reliability, the Airwave RF receiver module is compliant with the criteria of FCC and R&TTE.
The AWM682 RX module uses down conversion concept to convert the 5.8GHz FM RF signal to 480 MHz IF signal, and then obtain base band via PLL FM demodulation IC.
2. Feature:
Worldwide 5.8GHz ISM band (5725 MHzД5875 MHz).
Conform to R&TTE & FCC stipulation.
Compatible with both NTSC and PAL video formats.
Compact size and low power consumption.
Highly efficient FM-FM modulation/demodulation scheme.
Integrating Audio/Video input and output into one module base band PCB.
Provide with 7 selectable channels.
Received signal strength indicator (RSSI).
3. Application:
AV Sender
Baby Monitor
Surveillance
Wireless Camera
AIRWAVE TECHNOLOGIES INC. www.airwave.com.tw
Copyright 2008 by Airwave Technologies Inc. All Specification are subject to change without notice.
Doc No :
Design Kit – 5.8GHz Wideband FM Receiver Module
4. Function block:
5.725 GHzД5.875 GHz
Zo = 50 ohm
LNA LPF
Zo=50 ohm
CH1:5740 MHz, Lo=5260 MHz
CH2:5760 MHz, Lo=5280 MHz
CH3:5780 MHz, Lo=5300 MHz
CH4:5800 MHz, Lo=5320 MHz
CH5:5820 MHz, Lo=5340 MHz
CH6:5840 MHz, Lo=5360 MHz
CH7:5860 MHz, Lo=5380 MHz
Note: Lo=RF-IF
Mixer
VCO
PLL
SAW
Filter
IF Amp
FM
PLL
Demod.
Digital Control CKT
CH1 CH2 CH3
Channel Select
5. PIN define
Pin 01 GND
Pin 02 RSSI
Pin 03 A/R
Pin 04 A/L
Pin 05 Video
Pin 06 VCC
Pin 07 Bypass
Pin 08 N/A
Pin 09 Bit2
Pin 10 Bit1
Pin11
Pin12
Bit0
GND
RSSI
Video
Audio/L
Audio/R
GND
RFIN
Pin 13
Pin 14
AIRWAVE TECHNOLOGIES INC. www.airwave.com.tw
Copyright 2008 by Airwave Technologies Inc. All Specification are subject to change without notice.
Doc No :
Design Kit – 5.8GHz Wideband FM Receiver Module
6. PIN descriptions:
AWM682 RX
PIN NAME
01 GND Ground
Descriptions PIN NAME
08 N/A Not Used
Descriptions
02 RSSI Received signal strength indicator 09 Bit2 Ch select. (See table below)
03 A/R Right sound signal output
04 A/L Left sound signal output
05 Video Video signal output
06 VCC DC +5V supply in
07 Bypass DC Bypass
10
11
12
13
Bit1
Bit0
Ch select. (See table below)
Ch select. (See table below)
GND Ground
GND RF Ground Pad
14 RF IN RF received signal input Pad
(1)
Channel selection are seven channels by Pin20, Pin19 and Pin 18 for dip sw mode As shown below Κ
Pin09 Pin10 Pin11
Bit2 Bit1 Bit0
0 0
Descriptions
0 Pin09, Pin10, Pin11 connect to GND.
0
0
0
0
1
1
1
0
1
Pin 09 and Pin 10 connect to GND, Pin 11 OPEN.
Pin 09 and Pin 11 connect to GND, Pin 10 OPEN.
Pin 09 connect to GND, Pin 10 and Pin 11 OPEN.
1
1
1
0
0
1
0
1
0
Pin 10 and Pin 11 connect to GND, Pin 09 OPEN.
Pin 10 connect to GND, Pin 09 and Pin 11 OPEN.
Pin 11 connect to GND, Pin 09 and Pin 10 OPEN.
Receiver
Frequency
5740MHz
5760MHz
5780MHz
5800MHz
(CH1)
(CH2)
(CH3)
(CH4)
5820MHz (CH5)
5840MHz (CH6)
5860MHz (CH7)
Note 1: Forced Pin 02 (RSSI) to OPEN if RSSI function is unnecessary.
7. Absolute maximum ratings:
RF/ DC Parameters
Storage Temperature Range AWM682 RX (RSSI)
Supply voltage AWM682 RX(RSSI)
Min.
-25
-0.5
Typ.
-
-
Max.
85
5.5
Unit
°C
V
The maximum rating must not be exceeded at any time. Do not operate the device under conditions outside the above.
AIRWAVE TECHNOLOGIES INC. www.airwave.com.tw
Copyright 2008 by Airwave Technologies Inc. All Specification are subject to change without notice.
Doc No :
Design Kit – 5.8GHz Wideband FM Receiver Module
8. DC/AC Electrical characteristic:
(VCC=DC +5V, 25 °C)
RF/ DC Parameters
Supply voltage
Supply current
RF Input Level
O perating temperature
Operation Frequency Range
Channel Selection
Channel Frequency
Video-Audio Modulation/Dem odulation Type
Video
Output Signal Level
Frequency Response
S/N Ratio (100KHz, 1V
P-P
Sine Wave)
Audio
Output Frequency Range
Output Signal Level (Modulation Signal :
1kHz Sine Wave)
RSSI
RSSI output voltage (RF input –10dBm~-85dBm)
Min.
4.9
190
-85
Typ.
5
210
Max.
5.1
240
-10
Unit
V mA dBm
-10 - 60 °C
5725 5875 MHz
PLL Synthesizer, 7CH (See Tabl1)
CH1Κ 5740 MHz, CH2Κ 5760 MHz
CH3Κ 5780 MHz, CH4Κ 5800 MHz
CH5Κ 5820 MHz, CH6Κ 5840 MHz
CH7Κ 5820 MHz.
FM-FM
1V
P-P
, typ. (+/-0.2Volt)
+/-5 dB, max. 50Hz~5.5MHz
40dB, min.
50Hz ~ 20KHz
1.4~1.9Vp-p
0.2~1.5V
AIRWAVE TECHNOLOGIES INC. www.airwave.com.tw
Copyright 2008 by Airwave Technologies Inc. All Specification are subject to change without notice.
Doc No :
9. Test circuit:
Design Kit – 5.8GHz Wideband FM Receiver Module
AIRWAVE TECHNOLOGIES INC. www.airwave.com.tw
Copyright 2008 by Airwave Technologies Inc. All Specification are subject to change without notice.
Doc No :
10.
Dimension:
Design Kit – 5.8GHz Wideband FM Receiver Module
AIRWAVE TECHNOLOGIES INC. www.airwave.com.tw
Copyright 2008 by Airwave Technologies Inc. All Specification are subject to change without notice.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement