SSD D60 Axle Assembly Instructions

SSD D60 Axle Assembly Instructions
SSD D60 Axle Assembly Instructions
Note: The stock SCX10 axles will need to be disassembled with all gears,
bearings and shafts removed before starting.
1 Install gears with the stock bearings
Be careful not to over tighten the screws
2 Install diff cover
SSD-RC.com
1
Plastic D60 Axle for SCX10
Rear Axle with 4 Link
Use stock SCX10 straight rear axle shafts, bearings and rear lockouts.
3 Install upper link mount
After axle assembly is complete it can be installed on the SCX10 chassis in
the same way as the stock axles.
SSD-RC.com
2
Plastic D60 Axle for SCX10
Front Axle with 4 Link & Servo on Axle
Use stock SCX10 front axle C hubs, knuckles, bearings and shafts.
Install the upper link mount as shown in step 3.
4 Install the SSD servo mount plate (SSD00057) with stock servo mounts
Now install the knuckles, shafts, servo, steering links etc... as normal.
After axle assembly is complete it can be installed on the SCX10 chassis in
the same way as the stock axles.
SSD-RC.com
3
Plastic D60 Axle for SCX10
Front Axle with 3 Link & Panhard bar
For use with SSD00026 Chassis Mounted Steering kit for SCX10.
5 Install panhard mount
After axle assembly is complete it can be installed on the SCX10 chassis as
shown in the SSD chassis mounted steering assembly manual.
Recommended Parts
SSD00024 Titanium Steering Links for Axial SCX10
SSD00026 Chassis Mounted Steering Kit for SCX10
SSD00039 92mm Titanium Lower Links for SCX10
SSD00042 100mm Titanium Lower Links for SCX10
SSD00057 D60 Axle Servo Mount Plate
SSD00064 D60 Rock Shield Diff Cover (Grey)
SSD-RC.com
4
Plastic D60 Axle for SCX10
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising