Quick Guide - Optika Display

Quick Guide - Optika Display
Quick Guide
Optika Collaborate UHD Gen III 55”, 65”, 85”
Solution Deployment Guide
Box Contents
Parts Checklist
Display Power Supply
Touch Screen Pen
Camera Bracket
Pen Holder
Intel NUC Mounting Plate
Mountable Power Strip
Screen Cleaning Cloth
USB 3.0 Cable for USB Hub, 6’
USB 2.0 Cable for Touch, 6’
DisplayPort Cable, 6’
VESA Mount Screws
Cable Installation
Note: It may be easier to install cables prior to mounting. See “Optika_UHD_Setup_ALPHA” for cable install
instructions. For initial touch verification, see the section below titled “Display Validation and Set-Up”
Display Mounting
See the section titled “Optika_UHD_Mounting_ALPHA”.
For Salamander stand set-up, see the “salamander-fpsxl-500-600-assemply” guide.
Note: The power supply may be directly mounted to the particle board in the base of the stand, to the right
of the cable guide. Use wood screws no longer than ¾” in length.
Quick Reference Guide
1
Quick Guide
Display Validation and Set-Up
An HDMI based mini-pc has been provided for the purposes of testing the display prior to installation of the
user’s main system.
First, connect the wireless keyboard dongle to the USB 3 (blue) interface of the PC.
Next connect the included USB A-B cable to the PC.
Plug in the included micro-USB cable with power block to the PC.
(Note: some units may come with a pre-paired Bluetooth keyboard. Switch the keyboard “On” for operation)
Plug the HDMI end of the PC into any of the HDMI ports.
Next, connect the USB-B end into the “USB Touch” port of the display.
Connect the power block to the power strip mounted to the rear of the display.
Power on the PC via the button on the end of the device, then power on the display either via the remote
or buttons on the side of the display.
The unit will cycle through the inputs until the active port is found.
Note: This PC is slower than average devices and may take some time to boot. Touch should work immediately upon startup of the system.
A copy of all of the application files and guides are included in the root of the system drive in the “FlatFrog”
folder.
Test for touch function by selecting “FFWinTestDraw 2” on the display.
Test for function using the pen by drawing across the display.
Repeat with fingers.
Quick Reference Guide
2
Quick Guide
If this fails, verify that the top of the application window reads “FFWinTestDraw 2.0 (v1.0) (FW VERSION:
1904).” Firmware 1904 is the most current.
If this displays an older firmware, unzip, then run the appropriate firmware version executable. These are
included in the FlatFrog folder in the root of the C: directory.
Each file corresponds to the size of the display, ie “e-tk65-002a-v1904-upgrade.zip” corresponds to the 65”
display.
Run the “FFWinTestDraw 2”application again after completion of the firmware update.
In the event of unpredictable behavior, run “FlatFrogTestTool2” follow the on-screen instructions and contact support with the findings.
Troubleshooting
See the “Optika_UHD_Troubleshooting_ALPHA” guide for information.
Quick Reference Guide
3
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising