VIDEO VRARF MANUAL 2.0.pub

VIDEO VRARF MANUAL 2.0.pub
PEHRATEK WIRELESS VIDEO VRA VDS-1000 RF
OPERATOR’S MANUAL
REMOTE CONTROL
DUAL-ARM
Mounng Brackets
Power Pack
BUTTON 1=LEFT (Blue Dot)
BUTTON 2=RIGHT (Red Dot)
BUTTON 3=CENTER BOX
BUTTON 4=CENTER BOX TWO
Power Pack
DUAL-ARM
Mounng Brackets
INSTALLATION INSTRUCTIONS
1.) Posion VIDEO VRA near sound field loudspeakers using table-top mount, rolling cart, or wall mounng
brackets. Assure each panel’s secure mounng to the wall or sound field speakers. Right/le& assignment is
indicated by a red=right dot in upper corner.
2.) Route power pack power cords to nearest AC outlet. Secure cords to wall using Installaon Kit (oponal)
3.) Elongate RF antennas on back of RF module and posion them away from metal objects and sound room
walls.
4.) Test wireless remote control to assure proper acvaon and RIGHT/LEFT assignment.
RIGHT/LEFT Designator Color (RED=RIGHT)
Serial Number
Firmware memory card
RF Module
SMALL THIN REMOTE
Elongate antenna wire fully and
posion away from metal surfaces
(See separate instrucon
sheet on using this remote
control Enclosed)
DC power plug input 12 Volts
Used only to control:
Brightness
Contrast
Volume
Mounng Screws
Loudspeaker
PEHRATEK PRODUCTS 9285 Pierson Lake Drive, Chaska, MN 55318 (952) 470-9063 www.pehratek.com
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE/REMEDY________________
Display will not light up
Check power connecons, look for glowing green LED on side panel, make sure outlet is live
Acvates intermi?ently
Make sure that the antennas are outstretched and posioned away from metal objects.
No images are shown
Check that the file counter (behind RF module) is set to #9.
Images are distorted
Unplug unit from outlet for 3 minutes, restart system, Remove & reinsert memory card
Display Flickers
Replace ba?eries in the remote control. (CR-2016) Requires two ba?eries.
SOUND OPTION
Sounds associated with each video clip will play when the RIGHT/
LEFT bu?on is pressed. Use the small thin remote control to adjust volume or mute seFngs.
OPTIONAL ACCESSORIES
VIDEO CENTER MONITOR (VDS-510)
TO PAIR REMOTE WITH VIDEO MONITOR PANEL
1) Remove top plate to RF module (4 screws)
2) Locate push bu?on at the top of the PC board.
CENTER BOXES
LPA-440
LPV-300
3) Hold bu?on down for 3 seconds or more unl green LED
flashes.
4) While the LED is flashing press the bu?on on the remote
control to be paired with monitor. The LED will flash once
and then go out and exit the pairing mode in 15 seconds.
To clear channel memory: Hold top button down for 3 seconds
or more until the LED flashes. Release and hold down again for
3 seconds or more until the LED stops flashing. The LED will
flash twice to indicate that all codes have been deleted.
PEHRATEK PRODUCTS
9285 Pierson Lake Drive
Chaska, MN 55318
(952) 470-9063
www.pehratek.com
EXTENDED RANGE ANTENNA
ANT-001
INSTALLATION KIT
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising