ISP209B Portable Speaker for iPod and iPhone

ISP209B Portable Speaker for iPod and iPhone
ISP209B
Portable Speaker for iPod and iPhone
T a b l e o f C o n t e n ts
Warnings and Precautions........................................................................ 2
In the Box................................................................................................. 3
Features.................................................................................................... 4
Powering the Unit & Changing the Remote Battery............................... 5
Docking an iPod or iPhone & Playing a docked iPod or iPhone............. 6
Setting the Time & Setting the Alarm...................................................... 7
Using the Auxiliary Input & Using the Audio/Video Output.................. 7
Locations of Controls & Control Definitions..................................... 8-11
Parts & Service Information.................................................................. 12
Warnings and Precautions
This symbol, located on back or
bottom of the unit, is intended to alert
the user to the presence of uninsulated
“dangerous voltage” within the
product’s enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons.
This symbol, located on back or
bottom of the unit, is intended to alert
the user to the presence of important
operating and maintenance (servicing)
instructions in the literature
accompanying the appliance.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT,
FULLY INSERT.
To reduce the risk of electric shock, do not remove cover (or back). There are no user-serviceable parts
inside. Please refer any servicing to qualified service personnel.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
WARNING: To prevent fire or shock hazards, do not expose this unit to rain or moisture.
WARNING: Danger of explosion if the remote control’s batteries are incorrectly installed. Replace only
with the same or equivalent battery.
WARNING: The remote control’s button cell battery contains mercury. Do not put in the trash, instead
recycle or dispose of as hazardous waste
WARNING: Use of this unit near fluorescent lighting may cause interference regarding use of the remote.
If the unit is displaying erratic behavior move away from any fluorescent lighting, as it may be the cause.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
2
In the Box
• ISP209B
• AC/DC Adaptor
• Docking Brackets for iPod
• Remote Control, and Remote Battery
• Carrying Case
• Documentation
3
Features
iPod® / iPhone Docking Station
• Certified iPod Connector installed for iPod docking
• Recharge Circuit for iPod/mini/nano/photo/video/iPhone
• Includes docking brackets to fit iPod players
• Controls Connected iPod players
• iPod Authentication IC installed
Built-In Amplified Speakers
• Digital Volume Control
Jacks
• Aux-In Jack for shuffle and other Audio Players, 3.5mm type
• A/V Output Jack
0.9” LCD Display with White Backlight
• Clock with Adjustable Sleep Timer
• Dual Alarm
• Gradual Wake
• Wake to iPod or Buzzer
• Battery Backup keeps time during power outage, Back-Up Battery (not included)
AC/DC Powered:
• DC: Uses 4 AA Batteries, (not included)
• AC: 120V AC/DC Adaptor, UL Listed, included
• Uses 2 AAA Batteries for Clock Time Back-Up, Batteries (not included)
Remote
• Controls Docked iPod & Unit Functions
• Uses Button Cell Battery
4
Powering the Unit
To power the unit, plug the included AC/DC adapter into a standard AC
outlet (120V~60Hz)
The unit can also be powered by inserting 4 AA batteries into the
battery compartment.
The backup feature for the clock is powered by inserting 2 AAA
batteries into the battery compartment.
Changing the Remote Battery
To change the remote battery, slide the battery compartment out of the
remote, and replace the CR2025 battery with an equivalent battery.
CR2025
5
Docking an iPod or iPhone
Step 1: Locate the numbered bracket that fits the iPod or iPhone that will be
docked.
• Each included bracket has a number on it, indicating which iPod
or iPhone model that bracket is compatible with. See the separate
bracket chart page toidentify which bracket is needed.
Step 2: Snap the bracket into place over the iPod/iPhone connector in the
docking station.
• All brackets will only fit one way onto the dock.
Step 3: Connect the iPod or iPhone to the iPod/iPhone connector inside the
docking station.
• Once an iPod or iPhone is connected to the docking station, the unit
will amplify and charge the docked iPod or iPhone.
• If the unit is running on battery power, it will not charge a docked
iPod or iPhone.
Playing a docked iPod or iPhone
Step 1: Dock an iPod or iPhone into the docking station.
Step 2: Press the Power/Alarm Off Button to turn the unit on.
Step 3: Adjust the Source Button to switch to iPod Mode.
Step 4: Press the Play/Pause Button to play or pause the docked iPod.
Setting the Time
Step 1: Press the Power/Alarm Off Button to turn the unit off.
Step 2: Press and hold the Time/Menu Button.
Step 3: While holding the Time/Menu Button, press the Up/Hour & Down/
Minute Buttons to adjust the hour and minute.
Step 4: Release the Time/Menu Button to set the adjusted time.
6
Setting the Alarm
Step 1: Press the Power/Alarm Off Button to turn the unit off.
Step 2: Press and hold the one of the Alarm/Menu Navigation Buttons.
Step 3: While holding one of the Alarm/Menu Navigation Buttons, press the
Up/Hour & Down/Minute Buttons to adjust the hour and minute.
Step 4: Press the Source Button to select the alarm source; iPod Mode, Buzzer,
or cancel the alarm.
Step 5: Release the Alarm/Menu Navigation Buttons to set the adjusted alarm.
Using the Auxiliary Input
Step 1: Connect a mini-phono 3.5mm cable (not included) to the Auxiliary
Input on the unit and the audio output on an MP3 player.
Step 2: Turn the unit on by pressing the Power/Alarm Off Button.
Step 3: Press the Source Button to switch the unit to Aux Mode.
Step 4: Audio played through the connected MP3 player will now be heard
through the unit.
Using the Audio/Video Output
Step 1: Connect a mini-phono 3.5mm to RCA cable (not included) to the Audio/
Video Output and an external set of speakers or a television.
Step 2: Turn the unit on by pressing the Power/Alarm Off Button.
Step 3: Dock an iPod or iPhone.
Step 4: Press the Source Button to switch to iPod Mode.
Step 5: Audio and video played through the docked iPod or iPhone will now
play on the connected speakers or television.
7
Locations of Controls
1
10
2
11
3
12
4
5
13
14
6
7
8
15
9
1.
Dock for iPod/iPhone
Use the Dock for iPod/iPhone, with the correct bracket, to dock an iPod or iPhone to the unit.
2.
Alarm/Menu Navigation Buttons
Press and hold the Alarm/Menu Navigation Buttons, with the unit powered off, to set alarm 1 or 2.
Press the Alarm/Menu Navigation Buttons to move up and down through the menu of a docked iPod.
3.
Volume/Bass Buttons
Press the Volume/Bass Buttons to adjust the levels of volume or bass output from the unit’s speakers.
4.
Power/Alarm Off Button
Press the Power/Alarm Off Button to power the unit off or on, and to turn the alarm off after it
sounds.
8
Control Definitions
5.
Bass Button
Press the Bass Button to allow the levels of bass to be adjusted.
6.
Snooze Button
Press the Snooze Button to delay the alarm after it has sounded.
Press the Snooze Button with the unit powered on to set the sleep timer.
7.
Audio/Video Output
Use the Audio/Video Output to connect the unit to a television or external speakers.
8.
Auxiliary Input
Use the Auxiliary Input to connect an external audio source to the unit.
9.
Battery Compartment (Requires 4 AA Batteries and 2 AAA Batteries, not included)
10.
Time/Menu Button
Press and hold the Time/Menu Button, with the unit powered off, to set the clock.
Press the Time/Menu Button to move to the previous menu on a docked iPod or iPhone.
11.
Up/Hour & Down/Minute Buttons
Press the Up/Hour & Down/Minute Buttons to skip and search through songs on a docked iPod or
iPhone. Press the Up/Hour & Down/Minute Buttons to adjust the hour and minute when setting the
clock.
12.
Source Button
Press the Source Button to switch between iPod Mode and Aux Mode.
13.
Play/Pause Button
Press the Play/Pause Button to play or pause a docked iPod or iPhone.
14.
Enter Button
Press the Enter Button to make selection on a docked iPod or iPhone.
15.
DC Power Input
Use the DC Power Input to connect the unit to a power source.
9
Locations of Controls
16
21
17
22
18
23
19
20
11
Control Definitions
16.
Power Button
Press the Power Button to turn the unit off and on.
17.
Random Button
Press the Random Button to activate the Shuffle Mode on a docked iPod or iPhone.
18.
Play/Pause Button
Press the Play/Pause Button to play or pause a docked iPod or iPhone.
19.
Skip/Search Buttons
Press the Skip/Search Buttons to skip or search through songs on a docked iPod or iPhone.
20.
Volume/Bass Buttons
Press the Volume/Bass Buttons to adjust the levels of volume or bass output from the unit’s speakers.
21.
Mute Button
Press the Mute Button to mute the volume on the unit.
22.
Source Button
Press the Source Button to switch between iPod Mode and Aux Mode.
23.
Bass Button
Press the Bass Button to allow the levels of bass to be adjusted.
11
Parts Information
Address:
Phone:
Fax:
Email: 2116 Carr Street, St. Louis MO, 63106
1-314-621-2881
1-314-588-1805
partsinfo@dpi-global.com
Service Information
Address: 2116 Carr Street, St. Louis MO, 63106
Phone: 1-314-621-2881
Fax: 1-314-588-1805
Email: customerservice@ilive.net
Website: www.ilive.net
Version: v. 112408
To download this Instruction Manual in English, Spanish, or French visit the Support
section at www.ilive.net.
Para descargar este manual de instrucción en inglés, español, o francés visite la sección
de la ayuda en www.ilive.net.
Pour télécharger ce manuel d’instruction en anglais, espagnol, ou le Français visitez la
section de soutien à www.ilive.net.
© 2008 Digital Products International (DPI, Inc.)
All other trademarks appearing herein are the property of their respective owners.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising