Windows 7 Server/Client Setup with XP Mode

Windows 7 Server/Client Setup with XP Mode
Step-by-Step
Windows 7 Server/Client Setup with XP Mode
When using Windows 7 and XP Mode in a Server/Client scenario, Compass 2.0 should be
installed within XP Mode on both the Server and Client machines. The Windows Firewall
needs to be disabled in XP Mode on the Server machine. The firewall can remain enabled in
Windows 7, and in the Client machines. The Server machine needs to be set to utilize the
machine’s NIC directly, and the client machines need to be set for Shared Networking
(NAT). Follow the steps below to achieve these settings:
1. On the Server machine, within XP Mode, go to Start->Settings->Control Panel.
Double click on Windows Firewall and select “Off”. Click OK. Close Control Panel.
-1-
Tech Support
Updated 5/27/10
Step-by-Step
2. With the XP Mode screen minimized, but still open within Windows 7, you’ll see an
option for “Tools” then “Settings”:
NOTE: You can only see the “Tools” option when viewing the XP Mode application while
minimized. In full screen mode, this option is not shown.
-2-
Tech Support
Updated 5/27/10
Step-by-Step
3. On the Server, in the settings screen, click on Networking, the Networking settings
will be displayed in the pane on the right. By default, Shared Networking (NAT) will
be selected. Hit the drop down arrow and select the computer’s Network Interface
Card (NIC) from the drop down list. Click OK.
NOTE: The standard/server installation with the appropriate database selection will be done
on this machine. The client installation should be done on all other machines which will
access this database over the network. To view the server name for the server, go to
C:\Program Files\Honeywell\Compass20\Compass Installation Summary.log. This should
be the server name used for ALL client machines that will connect to this database.
-3-
Tech Support
Updated 5/27/10
Step-by-Step
4. On client machines, the default setting for Shared Networking (NAT) is correct. Go
to the Networking settings screen to verify:
-4-
Tech Support
Updated 5/27/10
Step-by-Step
When Compass 2.0 performs the install of SQL Express, it automatically enables networking
protocols for SQL. However, if SQL Express was already installed by another application,
these settings may not have been enabled. If you perform the above steps, but still have
issues connecting to a remote database over the network, check the protocol settings for SQL
by following the steps below.
1. Go to Start -> Programs ->Microsoft SQL Server 2005 -> Configuration Tools ->
SQL Server Configuration Manager:
2. Click on SQL Server 2005 Network Configuration, then click on Protocols for
COMPASS20:
-5-
Tech Support
Updated 5/27/10
Step-by-Step
3. The above screenshot shows the recommended Protocol settings for SQL Express
with Compass 2.0. If any of these protocols show Disabled, you can double click that
protocol, then set Enabled to “Yes”:
Once Shared Memory, Named Pipes, and TCP/IP are all enabled, attempt your network
connection to the server database again. If you still can not connect, contact Technical
Support at 1-800-645-7492.
-6-
Tech Support
Updated 5/27/10
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising