CatLinc VGA VGA-L Data Sheet (1.0).qxd

CatLinc VGA VGA-L Data Sheet (1.0).qxd
CatLinc™ VGA and VGA-L
CAT5 Signal DistributionSystem
Transmitter/Receiver pair sends VGA/RGBHV signal over CAT5/6.
Simple.
Intuitive.
Control.
SP Controls, Inc.
601 Minnesota St.
Suite 115
San Francisco, CA 94107
phone: (877) 367-8444
fax: (415) 642-2605
email: help@spcontrols.com
CatLinc VGA Transmitter and
Receiver
CatLinc VGA-L
FEATURES
The CatLinc VGA and VGA-L allows VGA (or RGBHV) connection between two devices using CAT5, CAT5e, or
CAT6 twisted pair cable. Connection is made to devices using standard male HD-15 connectors.
CatLinc VGA/VGL-L extends VGA signals up to 91m/300ft. At typical distances this product will provide excellent
image quality for all resolutions. It can be used for longer runs, but the image quality may be reduced (see chart
below). SP Controls recommends use of shielded CAT5 cable with the CatLinc system.
A single screwdriver adjustment at the Receiver allows fine-tuning for best picture detail. Includes transmitter,
receiver, and power supply.
CatLinc VGA-L
Transmitter includes a loopback VGA
for a local moniter.
(note: local loop must be terminated)
Also Available from SP Controls
The CatLinc VGA-L Transmitter provides a local loop-back female VGA cable to split the signal to a local display
in addition to the CAT5 connection to the Receiver.
Distance/Resolution Chart
50ft
100ft
150ft
200ft
250ft
300ft
640x480 @ 60 Hz
excellent
excellent
excellent
excellent
excellent
excellent
800x600 @ 60 Hz
excellent
excellent
excellent
excellent
excellent
fair
1024x768 @ 60 Hz
excellent
excellent
excellent
excellent
fair
fair
1280x1024 @ 60 Hz
excellent
excellent
excellent
fair
fair
poor
1600x1200 @ 60 Hz
excellent
excellent
fair
fair
poor
poor
Technical Specifications
CatLinc VID
Composite Video/Stereo Audio over
CAT5
CatLinc SVID
S-Video over CAT5
CatLinc HD
Component Video over CAT5
CatLinc DA8
Splits any CatLinc signal to as many
as 8 receivers.
CatLinc RS232
RS-232 to CAT5.
Power
Power Connector
Power Connector Requirements
Video Input/Output
Signal type
Connectors
Nominal Level
Minimum/Maximum levels
Impedance
Sync
Size
VGA Cable Length (approx.)
Shipping Weight
Optional Accessories
9 VDC@030 mA UL Approved
3.5mm O.D./1.3mm I.D. Center pos(d)
1 power supply (either end)
Analog VGA/RGBHV
1 male HD-15, RJ-45
0.7V p-p
0.3V to 5V p-p 75 ohms
TTL Compatible + or - polarity
Metal housing: 2.5"(L) x 1.15"(W) x 0.95"(H)
6"
2.0 lb.
CatLinc PS (additional power supply)
CatLinc TERM (75 ohm male VGA
termination plug for CatLinc VGA-L)
UL Listed
© 2005 SP Controls, Inc. All rights reserved. CatLinc™ and the SP Controls switch logo are trademarks of SP Controls, Inc.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising