USB Driver Installation Guide

USB Driver Installation Guide
Afterglow DMX512 Lighting Control Interface
USB Driver Installation Guide
Doc Revision 1.1
11/10/2006
Contents
Contents ......................................................................................................................................................................................... 2
1.
INTRODUCTION........................................................................................................................................................................ 3
1.1.
1.2.
1.3.
1.4.
2.
CONDITIONS OF USE ............................................................................................................................................................... 3
SUPPORTED OPERATING SYSTEMS .......................................................................................................................................... 3
HARDWARE INSTALLATION .................................................................................................................................................... 3
SYSTEM REQUIREMENTS ......................................................................................................................................................... 3
INSTALLATION......................................................................................................................................................................... 4
2.1.
USB DRIVER INSTALLATION .................................................................................................................................................. 4
1.
INTRODUCTION
To use the USB versions of any of the Afterglow DMX Interface range you must install the Afterglow USB driver
software.
1.1.
Conditions of Use
The authors accept no responsibility for any damage that may arise from the use of any supplied software.
1.2.
Supported Operating Systems
The USB Driver has been tested with:
Windows XP
Windows 2000
Windows ME
With proper installation the USB Driver should also run on Windows 98.
1.3.
Hardware Installation
Connect the Afterglow interface to a vacant USB port on your computer or USB Hub, using the supplied USB
A>B cable or the built in cable.
1.4.
System requirements
We recommend the following system specifications:
To control simple scenes, a minimum of:
200Mhz PC
Screen resolution of 1024x768 pixels
To use audio control, a minimum of:
800Mhz PC
Screen resolution of 1024x768 pixels
2.
INSTALLATION
To minimise the risk of encountering problems, please read and follow the instructions in this manual
thoroughly.
2.1.
USB Driver Installation
To install the USB Driver you must connect the DMX Interface to a vacant USB port on your PC or USB Hub
The Found New Hardware Wizard should detect the unit as an Afterglow DMX device and prompt for driver
installation.
If the Wizard askes to connect to Windows Update to search for a driver select the 'No, not this time'
option and click Next
Choose to 'Install from a list or specific location (Advanced)' and click Next
Select the 'Search for the best driver in these locations' option and ensure that the 'Include this location in
the search:' box is ticked.
Browse to your CD drive, then highlight Software > Afterglow USB Driver and click Ok then Next
Click on 'Continue Anyway' if the software warns you that the software has not passed Windows Logo
Testing.
The driver files should install automatically
Click Finish and the USB Drivers should be installed and your DMX Interface will be ready to use.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising