J00169 JR. Tool Adapter Operating Instructions - BAND-IT

J00169 JR. Tool Adapter Operating Instructions - BAND-IT
Operating
Instructions
J00169 JR.
Tool Adapter
To Install a BAND-IT Junior Clamp:
B
1
3
Place BAND-IT tool in vise. BAND-IT JR Adapter installs
over nose of tool. Insert BAND-IT Junior or Junior SID
Clamp in Tool and grip end of band by Band Gripper Lever
contained in the slide block assembly of BAND-IT tool.
A. Roll hose over approximately 30°,
BACKING OFF TENSION HANDLE ½ to 1
turn only through course of rollover,
depending on type and size of hose.
B. Grip buckle with hook in nose by pushing
cutter handle. Push cutter handle farther to
cut the band completing BAND-IT JR. Clamp.
4
2
CORRECT
Install clamp over hose assembly. Tension clamp by
turning the handle of BAND-IT Tool clockwise. To feel
movement of band, place finger on BAND-IT BAND at
buckle edge (shown by arrow) while tensioning with tool
handle. When you no longer feel band moving through
buckle, MAXIMUM PRESSURE HAS BEEN EXERTED BY
BAND-IT BAND.
The finished BAND-IT JR. Smooth I.D. Clamp.
Lip lock will be bent upward 90° and have a
cut-off edge (shown in green) that is flush to
the edge of the buckle. Edges shown in red
are too high or too low and may result in lower
lock strength or sharp edges.
NOTE: USE OF VISE IS OPTIONAL
FOR BAND WIDTHS OF ½” OR
LESS. WE STRONGLY SUGGEST
SECURING THE TOOL IN A VISE
FOR CLAMPS WIDER THAN ½”.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
www.BAND-IT-IDEX.com
Page 1 of 2
Document # P06287 rev. E
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
J00169 JR.
Tool Adapter
Repair Parts &
Assembly
7
4
1
2
6
3
ITEM 5: J93099 CUTTER BLADE KIT
SCREWS
BACKING
PLATE
J001 JR. ADAPTER REPAIR PARTS LIST
BAND-IT
ITEM #
DESCRIPTION
PART #
1
HANDLE
J01499
2
CAM
3
BODY
J02299
4
PIVOT CAM PIN
SCREW, SPECIAL
CUTTER BLADE
J93099*
5
BACKING PLATE
HEX KEY, SPECIAL
J00587
6
SHEAR HOOK
J00987
7
PIN, PIVOT HOOK
CUTTER BLADE
*NOTE: Replacement cutter
blade kit design may vary.
Replace all parts as a kit.
Refer to website for warranty information: http://www.band-it-idex.com/warranty.html
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
www.BAND-IT-IDEX.com
Page 2 of 2
Document # P06287 rev. E
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising