Spec Sheet: USB-EXT - USB over Twisted Pair Extender

Spec Sheet: USB-EXT - USB over Twisted Pair Extender
USB-EXT
USB over Twisted Pair Extender
The Crestron® USB over Twisted Pair Extender (USB-EXT) delivers
reliable USB signal extension for use in a boardroom, classroom,
auditorium, command center, or residence. Without any special setup or
configuration, the USB-EXT enables wire runs up to 100 meters (330
feet) over a single, low-cost twisted-pair cable[1].
The USB-EXT is compatible with USB 1.1 and High-Speed USB 2.0,
supporting virtually any USB device such as keyboards and mice, game
controllers, cameras, mobile devices, printers, hubs, and memory
devices.[2] It is compatible with Windows® and Mac® computers
without requiring any additional drivers.
The USB-EXT is composed of two extender components. The "local"
extender connects to your computer or other USB host, while the
"remote" extender provides connections for your USB devices at some
remote location. Linking the two extender components requires just one
run of inexpensive CAT 5 (or better) twisted-pair cable[1].
Link: (1) 8-pin RJ45 female, connects to Link port on the Local Extender[1]
> Extends USB signals 100 meters over CAT5 twisted-pair
cable[1]
>
>
>
>
>
USB 1.1 and 2.0 compatible
Provides 2 ports for USB devices
Supports up to 3 USB hubs (see specifications)
Works reliably without any programming or configuration
24VDC power pack included
Indicators - Local Extender
Power: (1) Blue LED, indicates operating power supplied via local power
pack
Link: (1) Green LED, indicates a valid Link connection to the Remote
Extender
Host: (1) Green LED, indicates a valid connection to the USB host
Activity: (1) Amber LED, indicates data activity on the Link interface
Indicators - Remote Extender
SPECIFICATIONS
Communications
Link: USB extension up to 330 ft (100 m) over UTP or STP cable[1]
USB Device Support: USB 1.1 and 2.0 compatible including 1.5 Mb/s low speed,
12 Mb/s full speed, and 480 Mb/s high-speed devices[2]
USB Hub Support: Any signal chain may include up to 3 USB hubs plus one USBEXT[2]
Maximum USB Devices: 14 USB devices, or 3 USB hubs with 11 USB devices
USB Host Support: EHCI (USB 2.0) and OHCI/UHCI (USB 1.1)
Connectors - Local Extender
Ground: (1) M2 threaded hole;
Accepts an M2 type screw to provide a chassis ground lug
DC IN 24V@1A: (1) 2.1 mm barrel DC power jack;
24 Volt DC power input (power pack included)
USB: (1) USB Type B female (cable included);
USB 2.0 device port for connection to the USB host interface
Link: (1) 8-pin RJ45 female, connects to Link port on the Remote Extender[1]
Connectors - Remote Extender
USB: (2) USB Type A female, USB 2.0 host ports;
For connection of USB mice, keyboards, game controllers, cameras, mobile
devices, printers, memory, hubs, and other USB devices[2];
Available Power: 500 mA @ 5 Volts DC per port
Ground: (1) M2 threaded hole;
Accepts an M2 type screw to provide a chassis ground lug
www.crestron.com
800.237.2041
USB: (2) Green/orange dual-color LEDs, green indicates a valid USB device
connection and orange indicates a current draw in excess of 500 mA at the
respective USB port
Power: (1) Blue LED, indicates operating power supplied from the Local
Extender via the Link connection
Link: (1) Green LED, indicates a valid Link connection to the Local Extender
Host: (1) Green LED, indicates a valid connection to the USB host at the
Local Extender
Activity: (1) Amber LED, indicates data activity on the Link interface
Power Requirements
Power Pack: 1 Amp @ 24 Volts DC600 mA @ 100-240 Volts AC, 50/60 Hz
power pack (included)[3]
Environmental
Temperature: 32° to 122°F (0° to 50°C)
Humidity: 20% to 80% RH (non-condensing)
Enclosure (Typical of 2)
Construction: Metal, black finish
USB-EXT
USB-EXTUSB
USB over Twisted Pair Extender
Dimensions (Typical of 2)
Height: 1.02 in (26 mm)
Width: 3.94 in (100 mm)
Depth: 2.99 in (76 mm)
Available Models
USB-EXT [6505317]: USB over Twisted Pair Extender
Notes:
1.
For the "Link" connection, use quality CAT5, CAT5e, CAT6 or better UTP
or STP cable. The maximum cable length is 330 ft (100 m). The minimum cable
length is 6 ft (1.8 m). Do not connect the LINK ports to an Ethernet LAN
or any other network or device. Crestron does not guarantee that all USB
devices are compatible with the USB-EXT.The power pack must be connected to
the Local Extender at the USB host location. Power is passed to the Remote
Extender via the LINK connection.
This product may be purchased from an
authorized Crestron dealer. To find a dealer, please contact the Crestron
sales representative for your area. A list of sales representatives is
available online at www.crestron.com/salesreps or by calling
800-237-2041.
Crestron and the Crestron logo are trademarks or
registered trademarks of Crestron Electronics, Inc. in the United States
and other countries. Mac is a trademark of Apple Inc., registered in the
U.S. and other countries. Windows is either a trademark or registered
trademark of Microsoft Corporation in the United States and/or other
countries. Other trademarks and trade names may be used in this document
to refer to either the entities claiming the marks and names or their
products. Crestron disclaims proprietary interest in the marks and names of
others. ©2011 Crestron Electronics, Inc.
Crestron Electronics, Inc. 15 Volvo Drive | Rockleigh, NJ 07647
Tel: 800.237.2041 / 201.767.3400 | Fax: 201.767.1905
www.crestron.com
All brand names, product names and trademarks are the property of their respective owners.
©2017 Crestron Electronics, Inc. | 15 Volvo Drive | Rockleigh, NJ 07647
Specifications subject to change without notice. 7/26/2017
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising