C-Nav1010 Quick Start Guide

C-Nav1010 Quick Start Guide
C-Nav1010 Users Manual
Quick Start Guide
Follow this Quick Start Guide to set up the standard
configuration of the C-Nav1010, designed for
productivity with minimal setup time.
Hardware Connect
Connect the supplied Positronic 9-pin connector of the
serial cable to Port A or Port B of the C-Nav1010.
Connect the DB9 end to the PC.
TNC Connector
1” Antenna Mount
Mount the supplied L1/L-band antenna to a mast, as
described in Chapter 3. (Ensure the antenna is in an
area with a 360º view of the sky).
Connect a GPS antenna cable to the GPS antenna.
Connect the other end to the TNC connector, labeled
ANT 1, on the receiver.
i
C-Nav1010 Users Manual
C-Nav1010R Only: To track C-Nav Correction Service
Signals at high latitudes, mount the L-band antenna to a
mast as described in Chapter 3. Connect a GPS
antenna cable to the L-band antenna. Connect the other
end to the TNC connector, labeled ANT 2, on the CNav1010R receiver.
Connect supplied DC power cord to 9-36VDC-power
source. Refer to Figure 4 for power cable pin
assignments.
Connect the Positronic 9-pin end of the power adapter
to the receiver power port.
GPS
C-Nav
On/Off
Data
Service
Depress the On/Off switch on the front panel for more
than 3 seconds to power on the receiver. All LEDs
illuminate for 3-5 seconds during power-up.
Your C-Nav1010 Hardware is now properly connected.
ii
C-Nav1010 Users Manual
Software Setup
C-Monitor/C-Setup
After installation, double-click on the C-Monitor or CSetup icon. Use the menu to select:
File->Open Port
Choose communications settings:
57600 baud, parity none, 8 data bits, 1 stop bit Press
"Ok"
This software will allow you to view the positioning data
in real-time and control the C-Nav1010.
For further information, see the C-Monitor and C-Setup
Users Manuals: http://www.cctechnol.com/support
C-NaviGator
After connecting the DB9 end of the serial cable to CNaviGator, use the menu to select:
Settings->Port, and choose the port.
Select the receiver type and choose communications
settings:
57600 baud, parity none, 8 data bits, 1 stop bit Press
"Ok"
The software will allow you to view the positioning data
in real-time and control the C-Nav1010.
For further information, see the C-NaviGator Users
Manual:
http://www.cctechnol.com/support
iii
C-Nav1010 Users Manual
TNC Connector 1 L1/
C-Nav Antenna
C-Nav1010M
Port B
RS232/422
(switchable)
Port A
RS232
C-Nav1010R
TNC Connector 1 L1
Antenna
TNC Connector 2
Optional Separate CNav Helix Antenna
Power
Port
Power
Port
Port B
Port A RS232/422
RS232 (switchable)
iv
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising