ATS-1070 Quick Start Guide UA EN Supplied items Before using the sound bar, make sure you have received all of the following items. Sound bar (ATS-1070) Power cable Optical digital audio cable Analog audio cable (RCA plug (L/R)-3.5 mm mini plug cable) Preparing the remote control Remove the battery’s insulating strip before attempting to use the remote control. Battery’s insulating strip Remote control Mounting template Spacers × 2 A CR2025 Lithium battery has already been inserted into the remote control. Use when mounting the sound bar on a wall Use when mounting the sound bar on a wall Owner’s Manual Quick Start Guide (This sheet) Installation Install the sound bar on the TV stand, etc. The sound bar can also be mounted on a wall, using the included mounting template and commercially available screws. Refer to the Owner’s Manual for additional installation instructions. NOTICE • Do not stack the sound bar and a BD player or other device directly on each other. Doing so may cause a malfunction due to vibrations. Remote control sensor Touch panel Manual Development Group © 2017 Yamaha Corporation Published 04/2017 KS-A0 AV16-0019 —1— Connection TV When only a TV will be connected to the sound bar, connect the two using one of the two methods shown below. An optical digital audio cable and an analog audio cable (RCA plug (L/R)-3.5 mm mini plug cable) are supplied with the sound bar. 1st choice 2nd choice OPTICAL OUTPUT HDMI INPUT 2 1 ANALOG OUTPUT L R 3 TV HDMI INPUT 2 1 3 TV 1. Remove the cap UPDATE ONLY SUBWOOFER OUT ANALOG 2. Check the direction of the plug TV IN UPDATE ONLY AC IN SUBWOOFER OUT ANALOG UPDATE ONLY OUT(ARC) SUBWOOFER OUT ANALOG TV IN TV IN OUT(ARC) AC IN UPDATE ONLY SUBWOOFER OUT ANALOG OUT(ARC) TV IN OUT(ARC) TV and a set-top box, or BD/DVD player Power cable When a TV and a playback device will be connected to the sound bar, connect the three as shown below. HDMI cables are not supplied with the sound bar. Use third-party HDMI cables. After all connections are complete, connect the supplied power cable to the AC IN jack on the sound bar and plug the power cable into an AC wall outlet. TV To an AC wall outlet Cable, satellite or network set-top box, or BD/DVD player AC IN AC IN OPTICAL OUTPUT HDMI OUTPUT HDMI INPUT 2 1 UPDATE ONLY SUBWOOFER OUT ANALOG TV IN OUT(ARC) 3 Watching TV 1 2 Press z (power) key on the remote control to turn on the sound bar. Press the TV key on the remote control to select TV as the input source. NOTE UPDATE ONLY SUBWOOFER OUT ANALOG IN AC IN • Press the ANALOG key on the remote control if the sound bar and TV are connected as shown with “2nd choice” above. Press the HDMI key on the remote control to watch a TV program received via set-top box. TV UPDATE ONLY SUBWOOFER OUT ANALOG OUT(ARC) TV IN OUT(ARC) When a TV that supports Audio Return Channel (ARC) will be connected, the sound bar can only play audio from the TV when it is connected as shown above. What is Audio Return Channel (ARC)? In order for the sound bar to play audio from a TV, the TV must usually be connected to the sound bar via an audio cable as well as an HDMI cable. If, however, the TV supports Audio Return Channel (ARC), TV audio signals can be input to the sound bar via the HDMI cable that outputs video signals from the sound bar to the TV. 3 4 Select the desired input source on the TV. Press the VOLUME (+/–) keys on the remote control to adjust the volume. For details, refer to the Owner’s Manual. ... and more features! – “HOME THEATER CONTROLLER” sound bar control app – Bluetooth connection – Clear voice The sound bar is equipped with a number of other functions not described in the Quick Start Guide. See the Owner’s Manual for details. —2—
advertising