RSV5-C328 camera data sheet

RSV5-C328 camera data sheet
RSV5-C328 Serial Command
ControlledCamera with Infrared Lens
A great very small camera from arduino egypt that can be fully controlled by
your Arduino or Mico-controller (TTL Version) or your PC (RS232 version).
This low cost camera can work for your robot, security system, or you can
put it on your moving vehicle(car/ airplane). It can take fixed pictures
(snapshot) or continuous video frames. It is equipped with infrared lens
which make it able to take photos even in very weak lighting (night vision).
This give great opportunity for using the RSV5-C328 camera in your project. You can
write your program such that the camera start taking snapshot when your GPS reading
give certain position. Or you can start taking photos at certain time during the day as
defined by your program. You can order the camera to start taking snapshot when your
object detection sensor (ultrasonic or PIR motion sensor) indicates there is an object.
The small dimensions and weight allows the camera to be put on a small servo and
controlled to rotate in all directions.
Future Electronics Egypt Ltd. (Arduino Egypt).
RSV5-C328 is controlled by twelve commands, like Sync, Initial, Snapshot, GetPicture
and so on. These commands are represented by two bytes and has four arguments.
The complete command packet is always six bytes long. Please read both RSV5-C328
user manual and code commands tutorials for better understanding of the camera
functionality.
1- Model Number: !RSV5-C328
2- Photo Format: Jpeg Compressed
3- Colors:! !
Colored photos as well as grey scale photos according to your
!
!
!
program settings. Built-in colour conversion circuits for 2-bit gray, 4!
!
!
bit gray, 8-bit gray, 12-bit RGB, 16-bit RGB or standard JPEG
!
!
!
preview images.
4- Lens
Lens Type: !
Infrared lens , 2.8 mm
Lens Filter: !
980 nm
What does mean?
This means that the camera can detect photos not only during day light but also at
!
night in weak light conditions because of infrared capabilities
5- Signal output data format: serial RS232 or TTL
What does this mean?
It means that the camera output signal data comes in RS232 and you can receive
data from the camera or give commands to camera using PC serial port or using any
serial RS232 input -output in your micro-controller. This direct connection to RS 232
serial port makes it easy to connect with the camera without any hardware in between
6- Resolution: VGA 640×480 or less (according to your program)
7- Baud rate: 115200 or less (according to your program)
8- Weight:
20 gram
9- Dimensions: :32mm*32mm,38mm*38mm
10- Pin Description:
4- Lens
Lens Type: !
Infrared lens , 2.8 mm
Lens Filter: !
980 nm
What does mean?
This means that the camera can detect photos not only during day light but also at
!
night in weak light conditions because of infrared capabilities
5- Signal output data format: serial RS232 or TTL
What does this mean?
It means that the camera output signal data comes in RS232 and you can receive
data from the camera or give commands to camera using PC serial port or using any
serial RS232 input -output in your micro-controller. This direct connection to RS 232
serial port makes it easy to connect with the camera without any hardware in between
Future Electronics Egypt Ltd. (Arduino Egypt).
6- Resolution: VGA 640×480 or less (according to your program)
7- Baud rate: 115200 or less (according to your program)
8- Weight:
20 gram
9- Dimensions: :32mm*32mm,38mm*38mm
10- Pin Description:
four pins as shown in the picture above as follows:
- Power: 5v
- Rx (UART data receive - input)
- Tx (UART data transmit - output)
- Ground
11- Working Modes: !
Snapshot or Video
What does this mean?
This means that you can make static or fixed pictures (Snapshots) or continuous
video frames according to your software command to the Camera. This is good as you
can take snapshots at certain conditions and then it is easier to make your photo
analysis (pattern recognition for example) with small amount and well defined data.
How does it work?
The camera is fully controlled through a group of commands sent by your Microcontroller or Arduino board or PC and respond to this commands. This commands are
called protocol and you have to program them. The specific protocol for this camera is
the famous protocol OV528.
Applications:
- Robots!
!
!
!
- Vehicles (cars or airplanes)!
- security
- Industrial monitoring process.
12- Camera Testing:
You can test the camera on your pc serial port using our testing software as shown in
picture. To download testing procedure , please click here and for a copy of our testing
software, please send us e-mail ([email protected]).
Future Electronics Egypt Ltd. (Arduino Egypt).
Future Electronics Egypt Ltd. (Arduino Egypt).
Future Electronics Egypt Ltd. (Arduino Egypt).
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement