takeMS DDR2-800, 2GB
takeMS TMS2GB264D08x-805xx
These Memory devices are JEDEC standard unbuffered DIMM modules,
based on CMOS DDR2 SDRAM technology.
These devices consist of CMOS DDR2 SDRAMs in FBGA packages on a 240pin glass epoxy substrate.The memory array is designed with Double Data
Rate (DDR2) Synchronous DRAMs for unbuffered applications.
The pipelined, multibanked architecture of DDR2 SDRAMs allows for
concurrent operation, thereby providing high, effective bandwidth.
Decoupling capacitors are mounted on the PCB board in parallel for each
DDR2 SDRAM, which provides proper voltage supply impedance over the
whole frequency range of operations, in accordance with JEDEC
These modules feature Serial Presence Detect (SPD) based on a serial
EEPROM device, using the 2-pin I2C protocol.
240-pin Unbuffered DDR2 SDRAM
JEDEC standard 1.8V I/O (SSTL_18-compatible)
Auto Refresh (CBR) and Self Refresh Mode
Off-Chip Driver (OCD) Impedance Adjustment
On-Die Termination (ODT) supports termination values of 50, 75, and 150 ohms
Serial Presence Detect (SPD) with EEPROM
Module layout is based on JEDEC standard routing guidelines
Impedance controlled 6-layer PCB Technology
JEDEC standard form factor (133.35 mm x 30.0 mm)
DQS edge-aligned with data for READs
DQS center-aligned with data for WRITEs
Operating Temperature 0°C ~ 75°C
Technical details
2048 MB longdimm module
128Mx8 IC organisation
x64 module organisation
800MHz / PC2 6400
double sided / 16 ICs
CAS Latency 5 at max. memclock
For pin configuration please check www.takems.com/support/index.php
If you have any questions regarding our products you can contact us via
email: info@takems.com
Order-No.: TMS2GB264D08x-805xx
Web: www.takems.com
E-Mail: info@takems.com
Tel: +49-7667-9414-0
Fax: +49-7667-9414-444
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF