Priva III Quick User Guide Priva III FAQs and Tips

Priva III Quick User Guide Priva III FAQs and Tips
❶ LED indicator
Connect Priva III to an audio source
TV with 3.5mm headphone jack: Connect Priva III to the TV using the
included 3.5mm audio cable
TV WITHOUT RCA analog out or headphone jack: Connect Priva III to the TV
with a Digital to Analog Audio Converter (please buy separately)
English
English
Priva III Quick User Guide
4
2 ON / OFF
5 USB in / charging socket
3 3.5mm audio jack
6
7
Digital Audio Converter
(please buy separately)
Pair and connect
Set
Pair
AUX
OFF
PAIRING MODE*
Upon first use, LED Get headset or
will blink BLUE & RED speaker into
alternately
PAIRING MODE*
Plug in the charging cable for power and
TV with RCA ANALOG
included RCA cable
Connect
4
1
* OUT: Connect Priva III to the TV using the
1.
Use for PC / Laptop
Priva III supports Micro USB Audio input for PC / Laptop. Most TVs can’t be used in this way.
Avantree
Priva II
Multi-link
blinks BLUE &
RED alternately
the LEDs slow down.
*PAIRING MODE: Discoverable mode for Bluetooth devices, normally
the LED blinks 2 or 3 times per second or blinks 2 colors alternately.
1
LED flashes BLUE once every 2 seconds
Restored factory default settings
LED flashes BLUE for 2 seconds
Pair and connect Priva III with
Headphones as above
4
Avantree Priva III
*Find the correct ANALOG output: You can connect wired earphones with the RCA cable
to test whether the sound is normal.
2
2. How do you reconnect?
There is no need to pair Priva III each use. It will auto reconnect to the last paired headphones/
receiver once you power on both devices and wait for 5~10s.
Step 1.
BLUE and RED alternately.
Step 2.
Step 3.
4. What kind of charger can be used for Priva III?
3.5 mm audio cable RCA cable
2
This could be because your headphones or receiver don't support aptX Low Latency Codec.
If Priva III can’t pair with your Bluetooth devices suddenly, please try to reset it:
3
*
LED flashes WHITE once every 5 seconds
LED flashes WHITE twice every 5 seconds
3. How do you reset (clear paired device info) Priva III?
Note:
Get the
second headset into
pairing mode, then
repeat step 3
Reconnect
LED flashes BLUE once every 5 seconds
LED flashes BLUE twice every 5 seconds
5~10s once powered on. Otherwise, please put both devices into pairing mode.
OFF
Connect Priva III to PC via the supplied
Micro USB sync charge cable
Hold 1s
Press and hold
LED flashes BLUE for 1 second
LED blinks BLUE and RED alternately
Priva III FAQs and Tips
3
ON
3
LED indicator
Power on
Pairing mode
Connected with SBC codec
Connected with Fast stream codec
Connected with aptX codec
Connected with aptX-LL codec
Digital Optical Cable
3.5 mm audio cable
ON
Status
Right-click the speaker icon on right-corner
of screen. And select “Playback devices”.
3
Set “Avantree
Priva III” as
“Default
Device”.
You can connect Priva III via the supplied micro USB cable to your own USB chargers
(wall charger/travel charger/mobile phone charger, etc.) with 5V/500mA-1A, or PC/TV USB port.
4
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising