Page 1 @m ms 3T l? Perfect Appearance Excellent Performance

Page 1 @m ms 3T l? Perfect Appearance Excellent Performance
7 FIS
PT 17
Perfect Appearance Excellent Performance
ws О ов wm +) m
Ч]
Чо a
fi ==
| [m] 205 [m] |
ВО + Please visit both our Facebook fonpage and our
[=] homepage for updated productinformation
bttp:/'www.facebook.com/payes/
FMSmadel/434689396557/695 WwWwW._{msmodel.com
СОРИ
Ба
| WARNING
WARNING: Read the ENTIRE instruction manual to become familiar with the features of the product
before operating. Failure to operate the product correctly can result in damage to the product, personal
property and cause serious injury.
This is a sophisticated hobby product and NOT a toy. lit must be operated with caution and common sense
and enquires some basic mechanical ability. Failure to operate this Product in a safe and responsible manner
could result in injury or damage to the product or other property. This product is not intended for use by
children without direct adult supervision.
This manual contains instructions for safety, operation and maintenance. It 1s essential to read and follow
all the instructions and warnings in manual, prior fo assembly, setup or use, in order to operate correctly
and avold damage or serious injury.
safety Precautions and Warnings
As the user of this product, you are solely responsible for operating in a manner that does not endanger
yourself and others or result in damage to the product or the property of others. This model is controlled
by a radio signal subject to interference from many sources outside your control. This interference can
cause momentary loss of control so it is advisable to always keep a safe distance in all directions around
your model, as this margin will help avoid collisions or injury.
Age Recommendation: Not for children under 14 years. This is not a toy.
Never operate your model with low transmitter batteries.
Always operate your model in an open area away from cars, traffic or people.
* Avoid operating your model in the street where injury or damage can occur.
« Never operate the model in the street or in populated areas for any reason.
« Carefully follow the directions and warnings for this and any optional support equipment (chargers, rechargeable
battery packs, etc.) you use.
- Keep all chemicals, small parts and anything electrical out of the reach of children.
* Moisture causes damage to electronics. Avoid water exposure to all equipment not specifically designed
and protected for this purpose.
* Never lick or place any portion of your model in your mouth as it could cause serious injury or even death.
=p
=>
Ar Av A — Ar a
о @
9 e NO
FMS Kindly Reminder \_/ $
| Pom
Thank you for your great attention and f
support to our company.
If there is any problem regarding the plane,
or any suggestion on our products, such asf
f manual, package, color scheme, even
structure, please feel free to contact J
us at [email protected]
MU Te ; ME мну Ни
—
JA не
page =
aire 776 NA S
Installing the Wing
1. Turn aircraft over so the bottom of fuselage 3. Turn aircraft over so the bottom of fuselage
faces up. faces low.
2. Put the lower wing in fuselage and secure itto ~~ 4. Attach left and right interplane struts to lower
fuselage using screws. wing and secure using screws(PA 2.36 4pcs).
(A. PA2.6*30 2pcs B. PA2.6*23 2pcs) Note: There is a remark of "R" or С" оп Пе
struts, please note.
| gr y] ———|
1\2 A Vase
e a. a
IS ве’
E
34
5. Attach left and right cabanes to fuselage using screws (PA 2.36 4pcs).
Note: There is a remark of R or L on the cabanes , wrong assembly will cause flexural wing
and can not fly well.
6. Turn aircraft over so the bottom of fuselage
faces up.
7. Attach left and right interpalne struts to
upperwing and secure using screws
(PA2.3"6 4pcs).
8. Attach left and right cabanes to upper
wing using screws (PA 2.376 4pcs).
19
FMS
step1
Installing the LED
9. Install the LED wire on the upper wing
as follow.
— pages >
p
FMS
step1
Installing the LED
10. Fasten the wire on the struts using
sticky tape.
11. Install the LED wire on the lower wing 12. Apply the sticker of "U.S. ARMY on
as follow. the lower wing as follow.
Pages >
Р
FMS
step2-3
Installing the Landini
1. Open the battery cover.
Pull the button as the arrow shows.
2. Apply glue onthe combined
side ofthe landing gear
connection.
nstalling elevator
1. Apply glue on the combined
side of the elevator connection
on fuselage.
2. Apply glue on the combined
side of the elevator.
~sFIMS
step4-5
Installing the Cowling, Propeller and s oe
E Fai :
talling the small parts of PT-17
1. Installing the dummy engine 1. Install the as follow
using screws.
(PA 2.3*6 3pcs)
2. Install the propeller making sure
it Is keyed into the motor shaft.
3. Install the spinner nut making sure
it Is tight enough.
sms
step5-6
ани "
— Installing the small parts of PT-17
3. Install the Pilots and windshield
as follow.
1. Battery position.
2. Battery cover
Note: Pull the button as arrow shows
when installing the cover.
step’ ms
— vez —————
Control Direction Test |
1. Move the elevator stick on the transmitter
forward and aft to check elevator pitch control.
When the stick is pushed forward, the elevator
should move down.
2. When the elevato stick is moved aft the elevator
should move up.
3. Move the alleron stick left and right to check
alleron roll control. When the stick is pushed
to the left, the left aileron should move up and
the right alleron should move down.
4. With the aileron stick pushed right, the right
aileron should move up and the left aileron
should move down.
5. Move the rudder stick left and right to check yaw
control. When the stick 15 pushed to the right the
rudder should also move to the right (if viewed
from behind the airplane).
6. With the rudder stick pushed to the left, the rudder
should move to the left (if viewed from behind
the airplane).
If at any time during the test the controls respond in
the opposite direction, it may be necessary tochange
the direction of operation of the flight controls.
Follow your transmitter instructions to change the
direction of the various flight controls.
Factory setting
Elevator Ailerons Rudder
“888
Fly the model at factory setting, For
pilots who wish to fly the model with
more control throw, adjust position of
linkages on servo arms and control
horns for increased travel.
- — fanes >
pages
Ems
| Main Specification
Specification Center of Gravity(C.G.)
Wingspan : 1050mm/43.3 In
Length > 850mm /34.6 In
Weight : 10600 /37.4 02 <
CG Position : 80mm
Battery : 11.1V LI-Po Battery Li
ESC : 30A
Motor : 3536-850kv
WingArea : 30.1dm?
Wing Load : 35.2g/dm?
RC System : 4 Channel, 4 Servos
And 1 Brushless ESC
Spare Parts List
Item# Description
SJ-101. Fuselage(Bare with all the plastic parts installed)
SJ-102. Main wing (Lower and top wing painted with all the plastic parts installed)
SJ-103. Elevator
SJ-104. Dummy engine.
SJ-105. Spinner(prop holder and spinner)
SJ-106. Cockpit
SJ-107. Windshield
SJ-108. Pilot (P1011)
SJ-109. Decal sheet
S5J-110. Screw set(Wing mounting, Interplane strut installing)
SJ-111. Front landing gear set
SJ-112. Motor board
S5J-113. Propeller(11*/)
SJ-114. Linkage rods( With clevis)
SJ-115. Motor shaft (With grub screw)
SJ-116. Wing strut set
SJ-117. Cowl
SJ-201. Motor(D3536- KV 850)
SJ-202. 9g servo (with arm)
SJ-203. Esc(30A)
SJ-204. Battery(11.1v, 1800mAh,25C)
— pages >
слете
Spare Part List
¿ra = =
SJ-107 SJ-102 SJ-103 SJ-104
SJ-105 SJ-106 SJ-107 SJ-108
= И \` om >
мень. % NES
SJ-109 SJ-110 SJ-111 SJ-112
|| a SJ-116
3 O
SJ-113 SJ-114 SJ-115 SJ-117
SJ-201 SJ-202 SJ-203 SJ-204
LAA RN
page10
7D 76 PA ©
Na 1
| Flying Tips
Range Check Your Radio System
After final assembly , range check the radio system with the FMS PT17. Refer to your specific
transmitter instruction manual for range test information.
Flying
Always choose a wide-open space for flying your FMS PT17. №15 ideal foryou to flyata
sanctioned flying field. If you are not flying at an approved site , always avoid flying near
houses , trees , wires and buildings. You should also be careful to avoid flying in areas where
there are many people , such as busy parks , school yards , or soccer fields . Consult local laws
and ordinances before choosing a location to fly your aircraft.
Landing
Land the model when you notice a reduction in power . If using a transmitter with a timer , set
the timer so you have enough time to make several landing approaches.
Due to the scale landing gear and characteristics of the FMS PT1/7, throughout flight and
when landing keep the wings level , even when taxiing.
You should land the FMS PT17 using a wheel landing (two point).
If the power is pulled all the way back when landing , the propeller acts like an air brake,
which can lead to the elevator being less effective . Therefore , it Is advisable to land with
some amount of power on as It allows more time to are the airplane for a smooth landing.
When setting up for landing, Fly the airplane down to the ground using 1/4 — 1/3 throttle
to allow for enough energy for a proper flare.
NOTICE: When finished flying , never keep the airplane in the sun. Do not store the aircraft
in a hot , enclosed area such as a car. Doing so can damage the foam.
First Flight Preparation
. Remove and inspect contents.
Charge flight battery.
Read this instruction manual thoroughly.
Fully assemble model.
Install the flight battery in the aircraft (once it has been fully charged).
Bind aircraft to your transmitter.
Make sure linkages move freely.
. Make sure the rubber ring has been properly slide on the clevis.
Perform the Control Direction Test with the transmitter.
10. Adjust light controls and transmitter.
11. Perform a radio system Range Check.
12. Find a safe and open area.
© ONO AWN
page
HA SF S
——————
_ NN
Please read the following instructions and fully understand It.
(1) Do not fly in strong wind or bad weather.
(2) Never fly the model in crowded areas, where there are lots of people,automobiles
on the road or power lines overhead. Also do not to fly around the airport.Please
make yourself enough room for the flying and operating, as the planecan travelat
high speed. Remember you are responsible for the safety of others.
(3) Children under the age of 12 should have an adult guide. Never recommend for
the children under the age of 14.
(4) Never leave the charger in wet conditions.
(5) The PT17 is made from PA and polythene which are tinder. When it meets the
heat, transfiguration can easily happen, so you must keep it away from heat.
(6) Do not attempt to catch the PT 1/7 while flying, please do not touch the propeller.
(7) Never leave this system unattended around children with battery in the unit, as
injury may be caused due to children s turning on the transmitter or the plane.
(8) During the preparation for the flight, please remember to turn on the transmitter
before connecting the battery pack.
(9) Close the throttle on the transmitter before connecting battery otherwise the motor
may operate.
page12
Email: [email protected]
Http: //www.fmsmodel.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement