iAdapter 3

iAdapter 3
Installation and Operating Instructions for the iAdapter™3 Remove the 9 (nine) screws from the back of the iAdapter™ as shown in the picture below. Connect the stereo plug from the iAdapter™ into the headset jack of the iPad®. Place the iPad® into the iAdapter™ and line up the reset button of the iPad® with the reset button of the iAdapter™ as shown in the picture to the right. Place the Home button cover slide door the slot of the iAdapter housing as shown in the picture to the right. Place the top housing of the iAdapter™ over the iPad® and make the home button cover can slide in the tracks of the top housing of the iAdapter™. Also align the top housing of the iAdapter™ with the bottom housing of the iAdapter™. Carefully hold both the top and the bottom housing of the iAdapter™ together and then turn it over onto a flat surface. Replace the 9 (nine) screws that will hold the iAdapter™ together. Designed by AMDi or www.amdi.net Installation and Operating Instructions for the iAdapter™3 Adjusting the volume on the iAdapter™and using the By‐Pass feature: The volume control on the iAdapter™ is different from the volume control on the iPad®. The volume control on the iAdapter™ only changes the volume from the amplifier inside the iAdapter™ which is plugged into the headset jack of the iPad®. To change the volume from the amplifier on the iAdapter™, slide the volume control switch to either Low or High. (Refer to the picture to the right). When the switch is in the OFF position the amplifier is by‐passed and the sound will play directly out the speaker on the back of the iAdapter by‐passing the amplifier. If the battery in the iAdapter looses power you can still use the iAdapter to play audio, but there is no amplification. Charging the battery inside the iAdapter™ and the Low battery indicator: The charging jack on the iAdapter™ only charges the battery inside the iAdapter™ for the amplifier. Plug the USB cable supplied with the iAdapter™ into the USB Charger Input jack on the side of the iAdapter™ (see picture at right). Plug the other end of the USB cable into the USB Charger supplied with the iAdapter™ and then plug the charging adapter in a wall socket. The Charger LED on the side of the iAdapter™ will light RED and the LED on the charging adapter will turn GREEN showing power is connected to the charging adapter and the iAdapter. When the Charger LED on the iAdapter changes to GREEN the battery is fully charged. It is recommended that you slide the volume control switch to the OFF position while charging the battery of the iAdapter. The charging LED on the side of the iAdapter is also a battery low indicator. It will Flash RED when the battery is down to 30% capacity, warning you that the battery is low and will need to be charged soon. iAdapter™ Charger & LED iPad® charging port USB Cable USB Charger Connecting a headset to the iAdapter™: Plug your headset into the jack labeled Phone Jack on the iAdapter™ (see picture to the right). When you plug your headset into the Phone Jack of the iAdapter™ all audio will be played into the headset and not through the speakers on the back of the iAdapter™. Designed by AMDi www.amdi.net 
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement