advertisement
▼
Scroll to page 2
и CC №» =" e BOBUACEINO Stroller “Q” INSTRUCTION FOR USE The stroller is intended for children: - from 6 months onwards, weighing up to 15 kg GE 150 9001:2000 ZN: 75.100.30107 TUV Rheinland InterCert WYC H A M ET P.H.P , WYCHAMET”, 42-263 Wrzosowa, ul. Hutnicza 1, POLSKA - POLAND, Tel/fax +48 (034) 327 55 35, [email protected], www.babyactive.pl Produkt zgodny z norma/Product according to: PN EN 1888:2012 Е Before using the stroller, read this manual carefully and keep it for future reference. Your child's safety may be threatened if you do not follow these instructions. Eu Guidance and warnings: WARNING: The seat is not suitable for children younger than 6 months. WARNING: Always use the harness when your child can sit up unaided. WARNING: Leaving your child in the stroller unattended may be dangerous. WARNING: The stroller is meant for ONE child only — the maximum load of the strolleris 15 kg. WARNING: Any load hung on the handle impairs the stroller stability. WARNING: Before using the stroller make sure that all folding mechanisms have engaged. WARNING: Always use the crotch strap in connection with the hip strap. WARNING: This product is not suitable for jogging or roller- skating. WARNING: Keep the stroller away from fire. WARNING: Do not use any extra accessories, not listed by the manufacturer. WARNING: Never leave the stroller with the child inside on a sloping surface, even with the brake blocked, as the pram may slide down. WARNING: Do not push the stroller up- or downstairs or up / down other slopes with the child in it as the child may fall out and/or the stroller handle or another frame component may get damaged, for which the manufacturer does not assume any liability. NOTE: Store small luggage items only in specially designated places and do not exceed the permissible luggage weight of 2kg NOTE: The maximum load of the shopping basket cannot be more than 2 kg. NOTE: Rocking the stroller sideways is prohibited as the child may fall out and/ or the stroller suspension components may get damaged, for which the manufacturer does not assume any liability. NOTE: Never carry the stroller upstairs holding it by the handle or bumper bar, as the child may fall out and/ or the stroller handle may get damaged. NOTE: Never fold or unfold the stroller when the child is seatedinit. NOTE: Mind your child's fingers while reversing the stroller handie. NOTE: Push the stroller at an even pace — the stroller speed should be adjusted to your walking speed. NOTE: It is not advisable to run or slide while pushing the stroller. NOTE: Do not use escalators; be very careful when using a lift with the child seated in the stroller. E Maintenance: -After each use wipe the stroller with a dry cloth. -The stroller upholstery can be washed with a soft sponge soaked in warm water (30- 400C) with soap or washing liquid. The stroller upholstery is not machine washable. -Do not allow the upholstery to soak up too much water during washing. -Do not expose the stroller to sunrays for along time. -Use raincovers to protect the stroller against getting soaked with rain. -Every 2 - 3 months clean the accumulated dirt (mud, sand) from the wheel axles and lubricate them with machine oil or lubricant. -Be careful not to damage the stroller frame and upholstery when transporting the stroller. -After using the stroller in rain or snow, dry the frame, wheels and axles with a dry cloth. -Do not store the stroller in cold and wet places. HB Guidance for the maintenance of the wheels: 1. Wheels with a foam tyre: Should the pram wheels squeak (this is applicable to the “Q” pram version with foam wheels), put a few drops of baby oil between the wheel ring and the wheel tyre (by previously pulling gently the tyre aside from the ring), and then twist the tyre carefully over the ring so that the tyre and ring contact surface is lubricated with oil over the whole wheel perimeter. 2. Inflatable wheels: A gradual drop in air pressure in inflatable wheels is not a fault, as the wheels of this type require to be periodically pumped up. When pumping up the wheels, do not exceed the maximum permissible air pressure value of 0.6 BAR! The Manufacturer shall not be held responsible for any damage to the wheel rings, inner tubes or tyres resulting from the wheels having been excessively pumped up! E Deviation from straight path: A loaded stroller may deviate by 0.5m from the straight path on every 4—5 msection. IT IS NOT A PRODUCT DEFECT. The “Q” stroller has a system of four independent shock absorbers — separate for each wheel. Each absorber behaves differently under load, depending on the location of the centre of gravity. Therefore, slight deviations from the straight path are not a defect but simply normal stroller operation under load. INSTRUCTION FOR У5Е — — E Description of stroller components (Photo 1) a - Main frame lock b - Bumper bar mounting f - Folding release rods g - Front wheel release devices device d - Footrest adjustment h - Rear wheel release device device d - Backrest adjustment i - Swivel wheel lock lever j - Brake e - Stroller handle m Unfolding the stroller: Unfold the stroller by lifting the handle (Photo 1-e) and pressing at the same time rear lock using foot (Photo 4) until both main frame locks click shut (Photo 1-a) to prevent the stroller from accidental folding. ATTENTION: Before using the stroller, make sure that the frame lock has been properly engaged. Hm Folding the stroller: a) Setthe backrestin the lowest (lying) position. ATTENTION: The stroller frame can only be folded when the backrestis in its lowest position. Failure to set the stroller backrest in the lowest (flat) position before folding the frame may result in serious damage to the backrest components, for which the manufacturer cannot be held liable. b) Detach the bumper bar c) Pull upwards at the same time the folding rods on both sides (Photo 1-f) releasing the main frame lock and fold the frame by lowering the stroller handle (Photo 3). Ш Installing and removing the wheels: a) Rear wheels: To mount the wheels onto the pram axles: by pressing down the wheel interlocking cotter pin first (Photo 1-h) slide the wheel home onto the axle, and then release the cotter pin. Pull the wheel gently towards yourself, and the wheel cotter pin should snap into the axle groove; a click sound should heard, which indicates that the wheel has been correctly mounted and locked on the axle (Photo 5 and 6). ATTENTION: Pull the wheel to make sure that it has been correctly and securely installed. To dismount the wheels: by pressing down the wheel interlocking cotter pin first pull the wheel towards yourself (Photo 6). b) Front wheels: To remove a front wheel, press the button (Photo 1-g) and pull the wheel downwards (Photo 7). To install a front wheel, insert the wheel axle into the hole in the front part of the stroller chassis (Photo 7). Pull the wheel until you hear a click sound. ATTENTION: Pull the wheel to make sure that it has been correctly and securely installed. mM Locking the swivel wheels for forward movement: To lock the swivel wheels for forward movement, press the button (Photo 1-i). Rotate until the wheels get locked (Photo 8). To unlock the swivel wheels for forward movement pull the button (Photo8). HB Backrest adjustment: Adjust the position of the buggy by pulling up the lever (with the tension member) provided on the back of the buggy rest (Photo 1-d). NOTE: First pull the rest adjustment lever up home, and then setthe rest position. Failure to follow the above procedure may result in major damage to the buggy rest elements, for which the Manufacturer takes no responsibility. Ш Installing/ removing the bumper bar: To install the bumper bar insert it on the tips of the mounting devices. When the bumper bar is mounted in place, you will hear its locks click (Photo 1-b), which will mean that the bumper bar has been correctly installed and securely locked. ATTENTION: Before using the stroller make sure that the bumper bar has been securely locked. After the bumper bar installation, fasten on it the crotch strap attached to the stroller upholstery to secure the child. The remove the bumper bar, press the buttons on both sides and take the bumper bar out of the mounting devices (Photo 1-a). E Harness instruction for use: The “Q” stroller is provided with a special five-point harness. To fasten the child with the harness fasten the crotch strap buckle with the right and left lock on the hip straps (Photo 9 and 10). WARNING: Always use the crotch strap in connection with the hip strap. ATTENTION: Before using the stroller make sure that the child is properly secured with the harness. WARNING: When the child can sit up unaided, always use the harness to fasten him in the stroller. E Brake operation: To brake the stroller, press the brake lever (Photo1-j) with your foot (Photo 11). To release the brake raise the brake lever. ATTENTION: Before riding the stroller always check if the brake has been released. The manufacturer cannot be held responsible for any damage to wheel racks and other components of the brake system resulting from the user's failure to follow the above instructions.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project