cn1910 s4x instructions

cn1910 s4x instructions
INSTALLATION INSTRUCTIONS
3” SIDEBAR
99-11 CHEVY SILVERADO 1500/2500 EXT CAB
PART # CN1910 S4X
PARTS LIST:
1
1
2
2
2
Driver/Left Sidebar
Passenger/Right Sidebar
Front Mounting Brackets
Center Mounting Brackets
Rear Mounting Brackets
4
4
4
2
2
2
½” x 2” Hex Head Bolts
½” Lock Washers
½” ID x 1 3/8” OD x 3/32” Flat Washers
10-1.50mm x 25mm Hex Head Bolts
10mm Lock Washers
10mm ID x 26mm OD x 1.5mm Flat Washers
Front Mounting
Brackets
Center Mounting
Brackets
Rear Mounting
Brackets
Page 1 of 4
12/17/07 (AM)
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. From underside of vehicle, remove the driver side body mount bolts. NOTE: Do not remove
body mount bushings.
3. Partially install front, center, and rear Mounting Brackets to vehicle using the factory body
mount bolts removed in step two. NOTE: Make sure that the support brace on the Front
Mounting Bracket is towards the front of the vehicle and the support brace on the center
Mounting Bracket is towards the body mount.
4. With help position Side Bar onto Mounting Brackets. Attach front and rear Mounting Brackets
to Sidebar using the included (2) ½” x 2” Hex Head Bolts, (2) ½” Flat Washers, and (2) ½” Lock
Washers. Do not tighten at this time.
5. Attach center Mounting Bracket to Sidebar using the included (1) 10-1.50mm x 25mm Hex
Head Bolt, (1) 10mm Flat Washer, and (1) 10mm Lock Washer. Do not tighten at this time.
6. Level and adjust Side Bar properly; and then tighten all hardware at this time.
7. Repeat steps 2-6 for passenger Sidebar.
8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild
soap may be used also to clean the Taillight Guard.
For gloss black finishes: Mild soap may be used to clean the Taillight Guard.
(Driver Side Installation Shown)
½” x 2” Hex Head Bolt
½” Lock Washer
½” Flat Washer
Front
Mounting
Bracket
Fig 1
Page 2 of 4
12/17/07 (AM)
10mm x 25mm Hex Head Bolt
10mm Lock Washer
10mm Flat Washer
Center
Mounting
Bracket
Fig 2
Rear
Mounting
Bracket
½” x 2” Hex Head Bolt
½” Lock Washer
½” Flat Washer
Fig 3
Installation
Complete
Fig 4
Smittybilt Automotive Products
400 W Artesia Blvd Compton Ca. 90220 (800)-717-8797
Page 3 of 4
12/17/07 (AM)
Page 4 of 4
12/17/07 (AM)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement