9. Check to see if the volume and mute buttons are working

9. Check to see if the volume and mute buttons are working
This remote is already preprogrammed to control your Set Top Box (STB). The instructions below will program this remote to control your TV. Please be sure that you are within arms reach of your TV, so that the devices can communicate effectively. 1. Make sure your TV is on and that you see a picture. 2. On the remote control, press the TV button once (top left side of the remote); it will blink once. 3. Then press and hold SETUP for 3 seconds until the TV button blinks twice. 4. Type 9 9 1. The TV button will blink twice. 5. Aim the remote control at the TV and press the POWER button once. The TV button will light up. 6. Press and release the CH+ key continuously, until the TV turns off. This may take two minutes or more. 7. Press POWER. The TV should turn on. Note: If the TV does not turn on during step 7, slowly press and release the CH– key until the TV turns on. 8. Press SETUP once to lock in the code. The TV button will blink twice to indicate that the code is saved. 9. Check to see if the volume and mute buttons are working. To program this remote to control your other devices, repeat steps 1 through 8, but substitute the appropriate key (VCR, DVD, AUD) for the device you wish to program. After you have completed the instructions on the reverse side, you can program your remote control to turn your Set Top Box (STB) and TV on and off simultaneously, also known as Master Power. Having Master Power set will eliminate the need to hit more than one button when turning your TV off and on. 1. Make sure your TV is on and you can see a picture. 2. Press the STB button (located on the top right side of the remote). The STB button will flash once when you press it. 3. Press and hold the SETUP button for 3 seconds until the STB button blinks twice. 4. Press 9 9 5. The STB button will should blink twice after you hit the 5 button. 5. Aim the remote at the TV and press the POWER button once. The STB button will blink once. 6. Press the TV button. Press the POWER button. Press the STB button. Press the POWER button. (The TV and STB buttons will light up when pressed.) 7. Press and hold the SETUP button for 3 seconds, until the STB button blinks twice. The Master Power is now set. 
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement