Devices

Devices
Devices
Infrared switches -
TECHNICAL CHARACTERISTICS
16623 - Infrared receiver for roller blinds
Technical specifications
16623 - Front view
•Supply voltage: 230 V~ 50-60 Hz
•Operating: monostable, bistable or bistable with timed OFF
•Infrared control, RC5 protocol
•Operating temperature: -5 °C - +35 °C
Infrared
receiver
Button UP
LED ↑
Controllable loads
•Resistive loads
:4A
•Motors : 2 A cosφ 0,6
LED ↓
Button DOWN
Operating
•Opens and closes roller blinds with:
- 2 buttons on the front of the device;
-control from several points with 2 NO push buttons (max.
range 100 m); do not use with built-in indicator unit;
-infrared control with 2 remote control buttons (up and down
buttons).
•Operating status indication (to be set at the time of the configuration);
•Monostable, bistable, bistable with timed OFF, confirmed by LED
•Programmable flashing LED.
16623 - Control from peripheral points with NO push
buttons L
N
Conformity to Standard
M
LV Directive
EMC Directive
EN 60669-2-1 Standard
16625 - Infrared receiver with dimmer
Technical specifications
•Supply voltage: 230 V~ 50 Hz
•Load on, regulation and off, with built-in button, with 01849
infrared remote control or NO non-luminous push buttons
connected in parallel.
•Stores the set regulation when the load is switched off (except
for power failure)
•Soft start: slowly brings the loads up from off to maximum or
to the regulated setting;
•Soft end: slowly brings the load down from on to off;
•Protection against short-circuit when switch on and overriding
with blow-out indication;
•Overheating with flashing indicator unit
•MASTER-SLAVE function: so long as the maximum permissible load of each dimmer is not exceeded, a single MASTER
device can be combined with up to 4 SLAVE 16601 dimmers
for a total maximum load of 2450 W (VA)
•Infrared switch, RC5 protocol
•Operating temperature: -5 °C - +35 °C
Controllable loads
•Incandescent and halogen lamps : 40-450 W
•Ferromagnetic transformers for low-voltage halogen lamps
: 40-450 VA
•Electronic transformers VIMAR 01860.60 max 4, or 01860.105
max 3
•Inductive response electronic transformers
: 40-300 VA
230 V~ 50 Hz (300 VA max up to 3 transformers, 240 VA max
up to 4 transformers; do not connect more then 4 transformers)
•Not suitable for motor control (e.g. exhaust fans, extractors)
M
or minimum value of the load is reached, the regulation stops
and can be reversed by releasing and then holding down the
button again.
Connections
•Connect device with a 16460 fuse carrier with fast blow-out
fuse with high-breaking capacity F 2,5 AH 250 V~ (07050.HF.2,5) type.
Conformity to Standards
LV Directive
EMC Directive
EN 60669-2-1 Standard
16625 - Front view
Infrared receiver
LED
Button
,
Operating
•Loads can be switched on and off by briefly pressing one of
the connected buttons, the button on the unit itself or the button on the remote control assigned to the receiver.
•To regulate the load, hold down the button on the unit or the
remote control; to reverse the direction of regulation, release
the button and then hold it down again. When the maximum
­­­144
16625 - SLAVE and NO push buttons connections
L
N
SLAVE
16460
16460
16625
16601
For a correct operating the distance
between MASTER
and SLAVE dimmers or NO push
buttons should not
exceed 100 m.
Infrared switches
Infrared receiver
16623
.B
Infrared receiver, 4 A 230 V~ relay output, for roller blind control, regulation with built-in buttons, from 01849 remote control or from peripheral points with NO push buttons, monostable or bistable function, visible in darkness, supply voltage 230 V~ 50-60 Hz - 2 modules
46,5
16623
grey
49,8
IDEA
36,5
16623.B
white
Infrared receiver
16625
.B
Infrared receiver with dimmer, supply voltage 230 V~ 50 Hz for: 40-450 W incandescent lamps, 40-450 VA ferromagnetic transformers, and 40-300 VA
inductive response electronic transformers, control and regulation with built-in button, 01849
L
remote control or from peripheral points with NO push buttons, MASTER function, MOSFET+TRIAC technology, visible in darkness
51
24,8
50,3
41
16625
grey
16625.B
white
16625 - Example of use
Controllable loads
10 m max
Charact. controllable transformer
16225
MASTER
16601
SLAVE
–
40 - 450 W
40 - 500 W
–
40 - 450 VA
40 - 500 VA
40 - 300 VA
40 - 300 VA
,
NOTE
Installation of 2 dimmers in the same mounting box, the loads controlled by each dimmer must be reduced so that their total does not
exceed the indicated values.
Side views show the overall dimensions and the flush depth in mm
* Only for Countries not members of the EU
Mounting boxes, frames and cover plates, from page 215
∆ Available until stock lasts
­­­145
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising