Installation Instructions

Installation Instructions
Installation Instructions
For 1 5/8" Annular Connectors
Tools/Materials
Connector
HCG-FRAMESET-158
UXP-DM-158
UXP-DF-158
12” Adjustable
Wrench
TQ-114-F18
Torque Wrench
Din-Male
HCG-CC
Safety Glasses
Alcohol Wipe
Always wear
safety glasses
when operating
tools.
SP-158 Prep/Strip Tool
Power Drill
RDCUTTER
Step #1: Prep
Straighten cable and position RDCUTTER in valley of
corrugation and cut off
cable squarely.
Blade lever is shown fully
closed. Open lever, lock
with pin, and remove tool.
Two ridges should be visible.
13113-01 revR
With a few simple steps, JMA compression connectors
can be easily and consistently installed on 1 5/8" cable.
Attach prep/strip tool to
drill. Open blade lever
and lock with pin. Insert
cable and actuate drill.
Hold drill and pull stripping
tool forward to eject the
cable slug. Make sure any
remaining cable is removed
from tool.
Actuate drill until outer conductor reaches fixed stop;
this will remove jacket.
Make sure blade is positioned over valley closest to
end of cable, release blade
lever and actuate drill until
cable is completely cut.
Re-apply stripping tool
to remove one more
corrugation of jacket for
three full visible ridges.
03-26-2014
7645 Henry Clay Blvd.
Liverpool, NY 13088
Support Tel: +1 315-431-7100
Inside US: 1-888-201-6073
customerservice@jmawireless.com | www.jmawireless.com
After stripping again, cable
is ready for connector
measurement marking.
Three full visible ridges
are acceptable. See that the
cut is made in the "valley."
Installation Instructions
For 1 5/8" Annular Connectors
Step #2: Install
Align connector as shown
with end of cap. Mark cable
jacket (using pen or marker)
in line with end of connector.
Pull/push back the insert to
allow connector/cable to
lay flat in frame. Make sure
connector is fully seated.
Use the provided
Pull/push
back thealcohol
insert to
wipe to
clean the outerto
allow
connector/cable
conductor.
PushMake
and twist
lay
flat in frame.
sure
until
connector isonto
fullycable
seated.
it reaches the cable mark.
Step #3: Compress
Press HCG tool trigger until gun
cycles. Do not pull or push on
tool or cable during compression.
After connector is fully compressed, connector will move
away from alignment mark.
Step #4: Torque
Add connector port seal (DIN female only) to ensure a moistureproof connection. The port seal
should sit in the flat area behind
the threads.
Cable preparation guide
Series
Torque (in. lbs.)
Hex Nut Size
DIN
216 (18 ft. lbs.)
1-1/4"
Use proper torque based on the type of interface.
Mobile-enabled:
JMAqr.com
Stabilize connector with adjustable wrench and always be sure to
torque the mating connector.
Scan for install video.
13113-01 revR
Compare to picture to determine if
correct cable prep was performed.
(For reference only)
03-26-2014
7645 Henry Clay Blvd.
Liverpool, NY 13088
Support Tel: +1 315-431-7100
Inside US: 1-888-201-6073
customerservice@jmawireless.com | www.jmawireless.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising