Mixed Voltage Fan Coil Package

Mixed Voltage Fan Coil Package
1
Mixed Voltage Fan Coil Package
Installation and Application Guide for Mixed Voltage Fan Coil
Fan Control for Mixed Voltages with 24VAC Transformer
VC1300E5000
RPP 110/130V 3 Spd
FCIB 1-Pk
VC2300E5000
RPP 220/240V 3 Spd
FCIB 1-Pk
2
Overview
This manual shows you how to install the VC1300/VC2300 and shows a typical application for the unit.
FEATURES
The Transformer has the following features:
•LED indication of relay status
•120 VAC or 230 VAC fused and 24 VAC thermal fuse.
•Captive screw for enclosure cover.
Technical Data
VC1300E5000
Number of outputs
Power supply
Contacts ratings
VC2300E5000
3 on/off outputs
3 on/off outputs
110 to 130 VAC 1 phase 50/60Hz
220 to 240 VAC 1 phase 50/60Hz
Resistive: 7 Amp / 1680 W ; Motor and or compressor: ¼ Hp / 10 LRA / 2.5 FLA
approved for 30,000 operations at 240 VAC
24VAC low voltage power output
Electrical connection
Operating temperature
Storage and transport temperature
Relative humidity
Weight
Metal enclosure
0.5A, 12 VA max
0.8 mm2 [18 AWG] minimum
0ºC to 50ºC [32ºF to 122ºF]
-30ºC to 50ºC [-22ºF to 122ºF]
5 to 95 % non condensing
400 g [0.9 lb]
NEMA2
Risk of electric shock. Disconnect power supply before connection and/or servicing.
Installation should be done by skilled and qualified technician. Observe local regulations concerning
provision of electrical installation. Install unit in electrical compartment.
Dimensions
The dimensions for the Transformer are as follows:
Dimension
A
B
C
D
Holes Dia.
Imperial (in) Metric (mm)
7 3/16
2 13/16
5 19/32
2 1/32
0.188
182.56
71.44
142.08
51.59
4.77
Class 2
Viconics Technologies Inc. | 9245 Langelier Blvd. St.-Leonard, Quebec, Canada H1P 3K9 | Tel: (514) 321-5660 | Fax: (514) 321-4150 | www.viconics.com | sales@viconics.com
028-0393-01
August 2016
3
Typical Application
The following shows a typical application for the unit.
Refer to Mixed Voltage Fan-Coil Application Package for details for how Application can be applied to a mixed voltage environment.
Viconics Technologies Inc. | 9245 Langelier Blvd. St.-Leonard, Quebec, Canada H1P 3K9 | Tel: (514) 321-5660 | Fax: (514) 321-4150 | www.viconics.com | sales@viconics.com
028-0393-01
August 2016
4
Mixed Voltage Application
In combination with the VT7300/VT8300 Series Room Controllers, the VC1300 and VC2300 allow control of a fan-coil requiring
mixed voltage for the following:
•line voltage for the 3-speed fan control (VC1300 is 120V unit and VC2300 is 220/240V unit)
•low voltage for the valve control
VT7300
NOTE: the VT8300 can also be
used for this application.
FAN COIL
VC2300
Heating Valve
0-10v
Com.
24v
Cooling Valve
0-10v
Com.
24v
240v
Power Supply
High Voltage Fan
HI
MED
LO
240v
VT8300
NOTE: the VT7300 can also be
used for this application.
FAN COIL
VC1300
Heating Valve
0-10v
Com.
24v
Cooling Valve
0-10v
Com.
24v
120v
Power Supply
High Voltage Fan
HI
MED
LO
120v
Viconics Technologies Inc. | 9245 Langelier Blvd. St.-Leonard, Quebec, Canada H1P 3K9 | Tel: (514) 321-5660 | Fax: (514) 321-4150 | www.viconics.com | sales@viconics.com
028-0393-01
August 2016
5
Installation
This procedure shows you how to install the Transformer.
1.Secure unit to wall or ventilation unit with four screws. Do not torque.
NOTE: screws not included with unit.
2. Remove one screw from hinged cover to access contact panel.
Viconics Technologies Inc. | 9245 Langelier Blvd. St.-Leonard, Quebec, Canada H1P 3K9 | Tel: (514) 321-5660 | Fax: (514) 321-4150 | www.viconics.com | sales@viconics.com
028-0393-01
August 2016
6
3.Secure electrical wiring to contact board according to below table.
Terminal Description
Terminals TB1 (Power Supply)
1- Neutral
2- Line
Terminals TB2 (Fan - Line voltage)
1- Neutral
2- Fan Speed High
3- Fan Speed Med
4- Fan Speed Low
Terminals TB4 (From Controller)
1- Common
2- 24 VAC Output
3- Binary Output 1
4- Binary Output 2
5- Valve Signal Input 1
6- Valve Signal Input 2
7- Fan Speed High
8- Fan Speed Med
9- Fan Speed Low
Terminals TB5 (Input / Output)
1- Common
2- 24 VAC Output
3- Binary Input 1
4- Binary Input 2
5- Valve Signal Output 1
6- Valve Signal Output 2
NOTE: THE CONTACT CONVERTER MUST BE CONNECTED TO EARTH WITH AID OF GROUND LUG LOCATED ON METAL BASE.
4.Close hinged cover and secure with one screw. Do not torque.
RECYCLING
Check with your local government for instructions on disposal of this product.
Viconics Technologies Inc. | 9245 Langelier Blvd. St.-Leonard, Quebec, Canada H1P 3K9 | Tel: (514) 321-5660 | Fax: (514) 321-4150 | www.viconics.com | sales@viconics.com
028-0393-01
August 2016
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising