Sony CFM-12 User manual
3-810-277-71(1)
Choosing Power Sources
Troubleshooting
Precautions
Rear Panel
There is no audio.
On safety/power sources
• Connect the AC power cord securely.
• Insert the batteries properly.
• Replace all the batteries if they are
weak.
• Adjust the volume.
• Set FUNCTION to the position you
want to operate.
• Should any solid object or liquid fall into the
player, unplug the player, and have it checked
by qualified personnel before operating it any
further.
• Unplug the player from the wall outlet when it
is not to be used for an extended period of
time.
• For battery operation, use four size D (R20)
batteries.
• When the batteries are not to be used, remove
them to avoid damage that can be caused by
battery leakage or corrosion.
• The nameplate indicating operating voltage,
power consumption, etc. is located at the
bottom.
Connecting the AC power cord.
Open the battery compartment and take out the
AC power cord. An opening in the compartment
door permits AC operation with the door in its
place. Then, connect the AC power cord to the
wall outlet.
Cassette cannot be inserted.
to a wall outlet
Using the player on batteries.
Insert four size D (R20) batteries (not supplied)
into the battery compartment.
Note
Replace the batteries when the OPR/BATT indicator dims or when the player stops
operating. Replace all the batteries with new ones.
Specifications
• Frequency range FM: 87.6-108MHz/AM: 5301,710kHz
• Antennas FM: Telescope antenna/AM: Built-in
ferrite bar
• Recording system 2-track, mono
• Frequency response 100-8,000Hz
• Speakers Full-range: 7.7cm (31/8 inches) dia x 1
• Power output 0.9W (at 10% harmonic distortion
in DC operation)
• Battery life
FM recording
Sony R20P : Approx. 24 hours
Sony LR20 alkaline : Approx. 55 hours
Playback
Sony R20P : Approx. 20 hours
Sony LR20 alkaline : Approx. 50 hours
• Power requirements 220V AC, 60Hz/6V DC,
four size D (R20) batteries
• Power consumption AC5W
• Dimensions Approx. 272 x 130 x 121.5 mm(w/h/
d)( 103/4 x 51/8 x 47/8 inches) incl. projecting parts
and controls)
• Mass Approx. 1.7kg (3lb 12oz)( incl. batteries)
• Insert the cassette properly.
• Press 6p to release 9 .
The r button does not function.
• No cassette is in the tape compartment.
• Make sure the safety tab on the cassette
is in place.
Poor playback,recording or
erasing quality.
• Dirty heads. Clean the illustrated
portions with a cleaning swab slightly
moistened with cleaning fluid or
alcohol.
• Demagnetize the heads and all metal
parts in the tape path with a
commercially available tape head
demagnetizer.
Pinch roller
Erase head
Record / Playback
Capstan head
Cotton swab
Operating Instructions
On placement/operation
• Do not leave the player in a location near heat
sources, or in a place subject to direct sunlight,
excessive dust or mechanical shock.
• Do not place anything within 10 mm of the
rear side of the unit. The ventilation holes
must be unobstructed for the player to operate
properly and to prolong the life of its
components.
• Since a strong magnet is used for the speakers,
keep personal credit cards using magnetic
coding or spring-wound watches away from
the player to prevent possible damage from
the magnet.
• Do not lift the handle when the telescopic
antenna is extended.
• If the player has not been used for a long time,
set it in the playback mode to warm it up for a
few minutes before inserting a cassette.
Notes on cassettes
Design and specifications are subject to change
without notice.
Radio Cassette-Corder
Side A
• Break off the cassette
tab from side A or B
to prevent accidental
recording. If you want
to reuse the tape for
recording, cover the
Tab for side A
broken tab with
Tab
for
side B
adhesive tape.
• The use of a cassette with more than 90
minutes of play time is not recommended
except for long, continuous recording or
playback.
If you have questions or problems concerning
your player, please consult your nearest Sony
dealer.
CFM-12
©1995 by Sony Corporation
Printed in Philippines
WARNING
To prevent fire or shock hazard, do not
expose the player to rain or moisture.
To avoid electrical shock, do not open
the cabinet. Refer servicing to
qualified personnel only.
Use TYPE I (normal) tape only.
Location and controls
Listening to the radio
1
FUNCTION
1
TUNING
MIC
TAPE
2
FM
TAPE
AM
FM
AM
2
Tune in the station you want.
2
With the side
you want to
play on
facing
forward.
STOP/EJECT
PLAY
REC
To turn off the radio
Set FUNCTION to TAPE/RADIO OFF.
3
Insert a blank tape.
With the side
you want to
record on
facing
forward.
STOP/EJECT
Insert a recorded tape.
Tape compartment
REW
To record from the radio
Tune in the station you want.
To record from the built-in microphone
Set FUNCTION to TAPE/RADIO OFF.
RADIO OFF
TUNING
FF
1
FUNCTION
RADIO OFF
PAUSE STOP/EJECT
Recording
Set FUNCTION to TAPE/RADIO OFF.
FUNCTION
OPR/BATT
VOLUME
Set FUNCTION to the band you want.
Playing a tape
Use TYPE I (normal) tape only.
3
Press r REC.
PLAY REC
Press 9 PLAY.
PLAY
To improve broadcast reception
Reorient the antenna for FM. Reorient the player itself for AM.
FM
AM
Tip
To
Press
Stop playback
p6
Fast-forward or
rewind the tape
) or 0
Pause playback
P
Eject the cassette
p6
When the tape reaches the end, the
playback stops.
To
Press
Stop recording
p6
When the tape reaches the end, the
recording stops.
Pause recording
P
Press the button again to
resume recording.
Tips
Press the button again to resume playing.
For the best results, move the player away from the TV.
When the tape reaches the end
The depressed button 0, ) or 9PLAY is released
automatically (Auto shut-off function).
•For the best results, use the AC power source.
• Adjusting the volume will not affect the recording level.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising