sata to ide converter

sata to ide converter
SATA TO IDE
CONVERTER
User Manual
DS-33150-1
Introduction
This Bridge Board is a converter solution for the Parallel Ultra ATA
Device. It has a standard 40 pin ATA port which can interface to IDE
device (hard disk, CDROM, DVD, CD-RW, etc.). It accepts Serial
ATA commands through the SATA interface from the host, decodes
the commands and converts them to parallel ATA commands to the
device. Response from the device through the parallel ATA bus are
deciphered, processed and converted to SATA protocol and send to
the host. The IDE to SATA 150 Converter supports the Serial ATA
Generation 1 transfer rate of 1.5GB/s (150MB/s) on the Serial ATA
side and is compatible with Ultra ATA-133 on the parallel ATA side.
Features
 Compatible with Ultra ATA 133 / 100 / 66 / 33 specifications
 Supports all types of ATATPI, ATA/133, ATA/100, ATA/66,
ATA/33, EIDE and IDE storage devices (DVD, DVD-RAM,
MO,CD-ROM, CD-RW, Hard Disk)
 100% hardware bridge converter to support PC, MAC and Linux
environment
Serial ATA Features
 Compliant with Serial ATA 1.0 specifications
 Supports Serial ATA Generation 1 transfer rate 1.5Gb/s
Package Contents
 1 x SATA to IDE adapter
 1 x User Manual
Note: Contents may vary depending on country/market.
Hardware Installation
1. Connect the IDE to
SATA adapter to your
IDE device, please remind
the direction of IDE port.
2. Plug the 4 PIN power cable
to IDE to SATA adapter.
3. Connect the 4 PIN power
cable to your IDE device.
4. Connect a SATA cable to
IDE to SATA adapter and
remember to plug the other
connector of the cable to your
computer.
Note1: IDE device must be set on Master Mode.
Note2: Please make sure that your PC is shut down during your
hardware installation. This SATA to IDE adapter with your IDE
device is not hot swap device and please shut down your
computer before your want to connect this device.
Hereby ASSMANN Electronic GmbH, declares that this device is in compliance with the
requirements of Directive 2014/30/EU (EMC), Directive 2014/35/EU (LVD) and the Directive
2011/65/EU for RoHS compliance. The complete declaration of conformity can be requested by
post under the below mentioned manufacturer address.
Warning:
This device is a class B product. This equipment may cause some radio interference in living
environment. In this case, the user can be requested to undertake appropriate measures to
prevent interference.
www.assmann.com
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising