Mk8 Keypad/Keyprox Installation Instructions

Mk8 Keypad/Keyprox Installation Instructions
Mk8 Keypad/Keyprox Installation Instructions
1.
Remove the keypad from its packaging.
2.
To fix the keypad to the wall, the back plate must
firstly be removed from the front plate. To do this,
remove the screw at the bottom of the keypad then
insert a flat-blade screw driver into both openings at
either side and twist gently to release the clips.
6.
If an off the wall tamper is required (note, this is
mandatory for a grade 3 installation), using a screw,
secure the sacrificial wall tamper (C) to the wall,
ensuring that the tamper knockout indicated, is still
connected to the back plate moulding
7.
Connect the A, B and power wires to the correct
terminals of the removable, four way connector
block.
Warning: When the keypad is separated ensure that antistatic precautions are taken with the keypad PCB to
avoid damage from ESD.
8.
3.
If using a wall run cable for the keypad position the
cable behind the back plate in the cable channels
provided. Use a sharp tool to remove the plastic from
the top or the bottom of the cable guides on the back as
required.
4.
Ensure that the keypad wiring is fed through the large
opening (A) on the keypad back plate,
5.
Position the keypad back plate on the wall and fix
securely using three screws through the mounting holes
(B).
9.
A B
Ensuring that the power is disconnected set the
keypad to a unique address using the 16 way rotary
switch on the PCB.
To re-assemble the keypad, connect the four way
connector block onto the pins on the keypad PCB.
Attach the keypad front plate to the back plate by
inserting the two clips (D) on the top of the keypad
front plate into the two apertures (E) at the top of the
keypad back plate, then gently push the bottom of the
keypad front plate into the back plate until it snaps
securely into place. Refit the screw.
Buzzer volume control
If required the buzzer volume can be adjusted by turning the
control (+ or -) as required with a small screw driver. The control
is located at the bottom right-hand corner of the PCB and is
marked VOL.
Warning : Do not over-tighten the screws as bending of the backplate will occur. This can force the tamper switch to open.
D
E
B
C
A
Figure 1 : Galaxy Mk8 Keypad Front and Back Plates
Specifications
Product Weight (Packaged)
Dimensions (mm)
Nominal supply voltage
Maximum Current
Nominal Current Backlight on
Nominal Current Backlight off
Humidity
Temperature
ACE type
800-07552 Rev D
EN50131 Compliance
Keypad
Keyprox
216g
222g
L152mm W93mm D25mm
12V
90mA
110mA
60mA
80mA
30mA
50mA
25% to 55%
-10 to +55 Deg Celsius
Type B
This product is suitable for use in systems designed to
comply with PD6662:2004 and EN50131-1: 2006
Independently tested for compliance to EN50131-3:
2009 by BRE Global Ltd
Honeywell Security
Security Grade - 3
Newhouse Ind. Est.
Environmental Class - II
Motherwell
Lanarkshire
ML1 5SB
UK
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising