Users Manual 6.23

Users Manual 6.23
TABLE OF CONTENTS
2
FRONT
3
BACK
4
MOUNTING BRACKET
5
6
1
VIDEO DOORBELL
7
9
COMPONENTS................................................... 3
BATTERY CHARGING....................................... 6
WI-FI SETUP ...................................................... 7
INSTALLATION................................................... 7
HARDWIRING .................................................... 8
ANSWERING A CALL....................................... 9
2
10
3
11
4
MAC ID:
XXXXXXXXXXX
Product name: Ring
Model name: Video Doorbell
FCC ID: YOPGS1011MEE
Power input: 8-24 VAC, 5Vdc 1 A
5
S/N:
Quick Install Guide
With Ring, you’re
always home.
1. Wide Angle HD Camera
2. Microphone
3. LED Ring
4. Push Button
5. Speakers
8
XXXXXXXXXXX
6. Setup Button
7. Micro USB Charging Port
8. MAC Address
9. Doorbell Wire Terminals
10. Mounting Hooks
11. Wire Management Hooks
BATTERY CHARGING
6
Charge your device using a USB-compatible wall charger
or laptop. To ensure your device is fully charged, charge
the device prior to Wi-Fi setup and installation.
LED RING LIGHTING SEQUENCES
LED Ring
spins blue.
Call Connected
LED Ring stays
fully lit blue.
Hardwired
LED Ring stays
dimly lit white.
Setup Mode
LED Ring
spins white.
Software Update
LED Ring
blinks white.
Factory Reset
LED Ring
blinks blue.
2. Line up the mounting bracket using the provided
mounting level.
Connect the diode to the terminals with the arrow
on the diode facing towards the doorbell chime as
shown below.
4. Install the mounting bracket using the provided
screwdriver bit, handle and drill bit.
Brick - use concrete screws and anchors
Concrete - use concrete screws and anchors
Stucco - use concrete screws and anchors
Wood - use wood screws
Vinyl - use wood screws
Doorbell Chime
Transformer
IN
Call Initiated
1. Remove doorbell button and power off your
transformer (for wired installation only).
If your chime is electronic, you may need to install a diode,
which is commonly found inside your current doorbell
button, or check with your doorbell manufacturer.
ANSWERING A CALL
AT&T
9
11:56 AM
END CALL
Mute Volume
For additional product information and
helpful tips, check out our support
forum at:
For immediate assistance,
please call us at:
DOMESTIC: 1-800-656-1918
INTERNATIONAL: +1 310-929-7085
7 days a week
9 a.m. to 5 p.m. PST.
Disable Microphone
End Call
6. Connect your doorbell wiring to the terminal screws
located on the mounting bracket
(for wired installation only).
Call Zoom
7. Place the device on the mounting bracket.
9. Provide power back to your transformer
(for wired installation only).
10
ring.com/help
5. Remove the mounting level.
8. Tighten the security screws at the bottom of the device
using the proprietary screwdriver bit. Please do not
over-tighten the security screws.
CUSTOMER SUPPORT
AC
LED Ring stays
fully lit blue.
INSTALLATION
8
If powering off doorbell wiring, the wiring
must be connected to a transformer and a
doorbell with a voltage of 8VAC - 24VAC to
ring your doorbell chime.
Rear
Battery Charging
Complete
Download the Ring app from the App
Store or Google Play. Open the Ring app
and select Setup Device. Follow the
in-app instructions to set up your Ring.
HARDWIRING REQUIREMENTS
Front
LED Ring spins
blue, then white.
7
Transformer
Battery Charging
WI-FI SETUP
To disable notifications for your Ring device,
select it from “My Devices”. Select “Device
Settings” and toggle notifications off.
1523 26th St.
Santa Monica, CA 90404
Hereby, Bot Home Automation, declares that this consumer
electronic is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC. The
declaration of conformity may be consulted at
www.ring.com/DoC.pdf.
Protect the device from direct sunlight. Install the device at dry locations and protect it
against rain and humidity. The device may not get contact to salt water or other
conductive liquids. The device must be charged only within a building in a dry state.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising