Dual 2.5“ SATA Mobile RAID USB 3.0 User Manual English

Dual 2.5“ SATA Mobile RAID USB 3.0 User Manual English
Dual 2.5“ SATA Mobile RAID
USB 3.0
User Manual
English
LINDY No. 43108
For Home and Office Use
Tested to Comply with
FCC Standards
© LINDY ELECTRONICS LIMITED
www.LINDY.com
&
LINDY-ELEKTRONIK GMBH
-
FIRST EDITION (Aug 2011)
English Manual
English 2
Device Overview
HDD ACTIVE LED
POWER LED
LOCK HOLE
HDD GATE
HDD ACTIVE LED
Mode Select
USB 3.0
Power
Switch
DC Jack
Hardware Installation
1. Unlock upper and lower covers, then open the door.
English Manual
English 3
2. Place one or two hard drive(s) in the slot. Make sure the SATA connector is lined up
with the connector inside the Mobile Rack.
3. Carefully push the hard drive into the Mobile Rack, so that the drive’s SATA
connector is seated securely, then close the door and lock it. It must be in the lock
position when in use. This prevents unexpected removal while working.
4. Adjust the DIP switch to set the storage policy:
1: ON
2: ON
1: ON
2: OFF
1: OFF
2: ON
1: OFF
2: OFF
5. Plug the included switching power adapter into the enclosure´s power adapter jack,
then plug the switching power adapter into a reliable power source.
6. Use the included USB 3.0 cable to plug the USB 3.0 Dual 2,5“ SATA Mobile RAID
into a USB 3.0 port of your computer and switch it on. Make sure the Power LED is lit.
Caution: Changing the RAID mode destroys data stored on the Mobile Rack,
If you have saved data on the drives, back up data before following these steps.
Note:
1. Users are advised to disable the device from the computer before unplugging the
cable or turning off the device.
2. If the hard drive does not support ACCESS signal, then the HDD ACTIVE LED
will not flash when the hard drive is in use.
3. If the system cannot detect the device, please go to device management and
enable it.
4. Do not open the door or turn off the power of the Mobile Rack while the hard drive
is busy, this may cause damage to you hard drive.
5. It must be in the lock position when in use. This prevents unexpected removal
while working.
6. Do not force the door to open while it is locked, otherwise, you will damage the
lock.
Driver Installation
Windows will automatically detect and install the drivers.
An additional drive icon will appear in MY COMPUTER when the USB 3.0 Dual
2,5“ SATA Mobile RAID is connected.
English Manual
English 4
Disconnecting from the Computer
Use Windows’ Safely Remove Hardware utility to turn off or disconnect the USB 3.0 Dual
2,5“ SATA Mobile RAID.
Windows 7
1. Verify that the HDD access LED is OFF before proceeding
2. Click the Safely Remove Hardware and Eject Media icon located in the taskbar
3. Click the „USB Mass Storage Device“
4. When the message Safe to Remove Hardware pops up, you can safely turn off or
unplug the enclosure
Windows Vista
1. Verify that the HDD access LED is OFF before proceeding
2. Double click the Unplug or Eject Hardware icon located in the system tray
3. Highlight „USB Mass Storage Device“, click Stop
4. Click OK twice, then Close
5. You can safely turn off or unplug the enclosure
Windows XP / Server 2003 & 2008
1. Verify that the HDD access LED is OFF before proceeding
2. Double click the Safely Remove Hardware icon located in the system tray
3. Highlight „USB Mass Storage Device“, click Stop, OK, then Close
4. You can safely turn off or unplug the enclosure
Radio Frequency Energy, Certifications
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna
 Increase the separation between the equipment and receiver
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
 Consult the dealer or an experienced technician for help
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance
could void your authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation
CE Statement, EMC Compatibilty
This device complies with EN Standards EN55022 and EN55024 according to the relevant EC EMC Directive. It
must be used with shielded cables only to maintain EMC compatibility.
Dieses Produkt entspricht den einschlägigen EMV Richtlinien der EU und darf nur zusammen mit abgeschirmten
Kabeln verwendet werden.
LINDY Herstellergarantie
LINDY gewährt für dieses Produkt über die gesetzliche Regelung hinaus eine zweijährige Herstellergarantie ab
Kaufdatum. Die detaillierten Bedingungen dieser Garantie finden Sie auf der LINDY Website aufgelistet bei den
AGBs.
WEEE (Waste of Electrical and Electronic Equipment),
Recycling of Electronic Products
In 2006 the European Union introduced regulations (WEEE) for the collection and recycling of all waste electrical
and electronic equipment. The wheelie bin symbol shown indicates that this product must not be disposed of with
household waste. Instead the product must be recycled in a manner that is environmentally friendly. For more
information on how to dispose of this product, please contact your local recycling centre or your household waste
disposal service. Each individual EU member state has implemented the WEEE regulations into national law in
slightly different ways. Please follow your national law when you want to dispose of any electrical or electronic
products.
More details can be obtained from your national WEEE recycling agency.
Germany / Deutschland
Die Europäische Union hat mit der WEEE Direktive umfassende Regelungen für die Verschrottung und das
Recycling von Elektro- und Elektronikprodukten geschaffen. Diese wurden von der Bundesregierung im Elektround Elektronikgerätegesetz – ElektroG in deutsches Recht umgesetzt. Dieses Gesetz verbietet vom 24.März 2006
an das Entsorgen von Elektro- und Elektronikgeräten über die Hausmülltonne! Diese Geräte müssen den lokalen
Sammelsystemen bzw. örtlichen Sammelstellen zugeführt werden! Dort werden sie kostenlos entgegen genommen.
Die Kosten für den weiteren Recyclingprozess übernimmt die Gesamtheit der Gerätehersteller.
LINDY No 43108
1st Edition, August 2011
For Home and Office Use
Tested to Comply with
FCC Standards
www.lindy.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising