Model 3740 32 Channel Isolated Switch Card Specifications 28

Model 3740 32 Channel Isolated Switch Card Specifications 28
Model 3740
Keithley Instruments, Inc.
28775 Aurora Road
Cleveland, Ohio 44139
1-888-KEITHLEY
www.keithley.com
32 Channel Isolated Switch Card Specifications
28 Form C relays and 4 high power Form A relays
RELAY SWITCH CONFIGURATION: 32 general purpose independent channels. 28 channels of FORM C
switching at 2A and 4 channels of FORM A switching at 7A. Relays can be connected to each other and backplane
via removable terminal blocks.
CONTACT CONFIGURATION:
GENERAL PURPOSE: 1 pole FORM C.
HIGH CURRENT: 1 pole FORM A
CONNECTOR TYPE: Two 50 pin male D-shells.
MODEL 3740-ST SCREW TERMINAL OPTION:
#22 AWG typical wire size with .062 inch O.D. 84 conductors maximum. #16 AWG maximum wire size with
.092inch O.D. 44 conductors per card maximum.
MAXIMUM SIGNAL LEVEL:
FORM C: 300V DC or RMS, 2A switched (3A carry), 60W, 125VA.
FORM A: 250VAC 7A, 30VDC 7A, 210W
COMMON MODE VOLTAGE: 300V DC or RMS between any terminal and chassis.
VOLT-HERTZ LIMIT: 8x107.
CONTACT LIFE:
FORM C > 105 operations at max signal level.
FORM C >108 operations no load.1
FORM A > 105 operations at max signal level.
FORM A > 5x107 operations no load 1
CHANNEL RESISTANCE :< .5 Ω at end of contact life
CONTACT POTENTIAL: ≤ ±3µV typical per contact
ISOLATION:
CHANNEL TO CHANNEL: >109Ω, <200pF
COMMON MODE: >1010Ω, <150pF
CROSSTALK CH-CH (50Ω load- 50Ω source):
100KHz : <-50dB
1MHz: <-35dB
10 MHz: <-15dB
BANDWIDTH: 30MHz
1
Minimum signal level 10mV,10uA
Specifications are subject to change without notice.
SPEC-3740 Rev. A / September 2007
Page 1 of 3
Model 3740
Keithley Instruments, Inc.
28775 Aurora Road
Cleveland, Ohio 44139
(440) 248-0400
www.keithley.com
32 Channel Isolated Switch Card Specifications
28 Form C relays and 4 high power Form A relays
GENERAL:
OVER-TEMPERATURE: Temperature sensor indicates over temperature.
ACTUATION TIME: Form C 4ms, Form A 10mS
RELAY TYPE: Form C Latching electromechanical, Form A nonlatching electromechanical.
RELAY DRIVE SCHEME: Direct
INTERLOCK: Backplane relays disabled when interlock connection removed.
OPERATING ENVIRONMENT:
Specified for 0ºC to 50ºC.
Specified to 70% R.H. at 35º
STORAGE ENVIRONMENT: -25ºC to 65ºC
WEIGHT: 2.5LBS
SAFETY: Conforms to European Union Directive 73/23/EEC, EN61010-1
EMC: Conforms to European Union Directive 2004/108/EC, EN61326-1
ACCESSORIES AVAILABLE:
3790-KIT50-R pin female D-sub connector kit (contains 2 female D-sub Connectors and 100 solder cup contacts)
3721-MTC-3 50 pin D-sub female to male cable, 3m
3721-MTC-1.5 50 pin D-sub female to male cable, 1.5m
3740-ST screw terminal block
Specifications are subject to change without notice.
Page 2 of 3
SPEC-3740 Rev. A / September 2007
Model 3740
Keithley Instruments, Inc.
28775 Aurora Road
Cleveland, Ohio 44139
1-888-KEITHLEY
www.keithley.com
Specifications are subject to change without notice.
SPEC-3740 Rev. A / September 2007
32 Channel Isolated Switch Card Specifications
28 Form C relays and 4 high power Form A relays
Page 3 of 3
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising