Wiring Diagram
TECHNOSYSTEMS & CONNECTIONS ARCHITECTURE
PROFESSIONAL AUDIO, SCENIC ARTS & BROADCAST
Wiring Diagram
Video BNC Connector
11026(0.8/3.7)-10951(1/4.6)-5327(1.6/7.2)
Page. 1
DATE: 08-11-11
ED.1
STEP 1:
Strip the cable. We strongly recommend the use of Rotary Cable Stripper REF:
10206, for proper preparation of the cable.
Please read the instructions for use, supplied with the tool.
Stripping dimensions
A = 6.5 mm.
B = 6.5 mm.
You can use the cutting guide on the connector body to check for proper stripping
dimensions.
Do not cut the braid or mark centre conductor.
STEP 2:
Prepare the cable Fold exposed braid back over jacket.
For “Quad shield”, “Tri shield” and “Super shield” cables: Remove the outer braid
and foil only.
Fold back the inner braid. Leave the inner foil attached to dielectric.
Make sure, that the foil is undamaged and smooth.
STEP 3:
Mount the connector Push the connector over the foil and allow the support
mandrel to slide between the foil and braid.
A rubber tool for cable support can be used to keep a better grip on the cable
during installation REF:9666.
Press and turn until the connector is in place (you can feel the mechanical stop).
Step 4.
Compress the connector Compress the connector using the “Universal”
compression tool REF:5323.
Make sure to use the right adjusted tool head with the plunger tip for BNC
(marked “B”) installed.
Please read the instructions supplied with the tool.
Insert the connector with the cable in the tool and close the tool handle
completely.
Open the handle and remove the compressed connector.
“Universal” Ref:5323
Rubber tool for cable support Ref:9666
Avda. de la Constitución, 40 // 19110 MONDÉJAR (Guadalajara)
Tfnos.: 0034 949 38 54 44 / 0034 949 38 56 98 // Fax: 0034 949 38 56 43 // www.pinanson.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising