CABLE AND CONTROL KIT FOR LESLIE MODEL 16

CABLE AND CONTROL KIT FOR LESLIE MODEL 16
CABLE AND CONTROL KIT FOR LESLIE MODEL 16
011866
Installation
Make sure Amplifier is turned off before making installation of Kit.
1. Plug 5 contact of Kit into Leslie Model 16 as shown at "U" in photo.
2. Place Switch Control Box "V" at some convenient location for player.
3. Plug Line Cord from Leslie Model 16 into convenient wall outlet, and turn on switch
"T".
IMPORTANT: After transporting speaker, plug Line Cord into wall outlet, turn on
power switch at Leslie cabinet, push Tremolo Switch and wait 5 seconds and push
again.
4. Make sure that the cross over assembly "W" is plugged into the 6 contact sockets.
5. Connect black wire at point "C". This is the common wire connected between the
amplifier and speaker. Use wire nut provided.
6. Cut hot wire from amplifier to speaker and connect red and white wire "A" and
"B". Use wire nuts provided.
7. To properly use wire nuts, strip each wire approximately 3/8". For further
information of Model 16 Operations and Control Switch functioning, see Owner's
Manual.
011866 Cable & Control Kit
011569
012377
012385
013235
026401
026419
026427
026435
Adapter
Cross-over Network
Cable and Control Assy.
Grommet
Washer
Nut
Switch SPOT SW2
Switch SPST SWl
026443
026456
027565
028076
029264
029546
060467
Page 1 of 2
Housing Cover
Switch Housing
Label
Wire Nut
Socket 5 contact S2
Socket 6 contact Sl
Capacitor .01 1 K Volt
Page 2 of 2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising