Episode ES-ESS-BRKT-IW-6 In-Wall Speaker Brackets Installation manual
advertisement
INSTALLATION MANUAL
EPISODE ACCESSORIES
page | 2
PRE-INSTALL
Pre-Construction Brackets
Pre-Construction brackets are color coded and available in four sizes:
Color Model
Yellow IC-4
Green
Red
IC-6*
IW-6
IC-8
IW-8
Blue IWLCR-6
* For POINT-6 models, refer to IC-8 cutout dimensions.
1. Connect the wing to the bracket.
NOTE: Press and hold the release button, then slide the wing away from the bracket to disconnect.
Edge Plate
Release
Button
The in-ceiling speakers include an egde plate to secure if mounting the speaker against a joist.
page | 3
The in-wall speakers require four points of connection to provide proper support. Two bracket wings are included and must be cut into four segments using tin snips. Connect the four wing segments to the bracket and secure to studs.
Bracket Bracket
Wing
Segments
Wing
Segments
2. Use the 1" markers as a placement guide for aligning the brackets.
Drive a screw through the metal wings to secure into the desired position.
Bracket
1" Markers
Wing
3. Secure wiring within reach of the bracket for easy access.
page | 4
INSTALL
Rear Enclosures (For Signature Speakers Only)
1. Remove the speaker interconnect cover.
Speaker
Interconnect
Cover
2. Attach the speaker to the appropriate enclosure before mounting.
3. Use the embossed guide to align the enclosure with the product label.
Align with
Product
Label
4. Secure enclosure to speaker using the screws provided.
Note: In-wall models include additional screws around the magnet of the speaker.
5. Connect wires to the terminals on top of the enclosure.
page | 5
Refer to the following charts to verify the correct dimensions prior to cutting drywall.
Model Cutout Dimension Mounting Depth with Enclosure
IC-4
IC-6*
6.2”
8.3"
5.9”
6.2"
IC-8 9.7" 6.6"
* For POINT-6 models, refer to IC-8 cutout dimensions.
Model Cutout Dimension Mounting Depth with Enclosure
IW-6
IW-8
LCR
11.7" x 7.6"
13.7" x 9.0"
14.4" x 7.6"
3.8"
3.8"
3.8"
page | 6
POST-INSTALL
Grille Options
See the chart below for available grille options.
Speaker
Grille
Round
Rectangular
Square
In-Ceiling
Thin Bezel Bezel-less
In-Wall
Thin Bezel Bezel-less
Install
For round in-ceiling and rectangular in-wall grilles , simply attach onto the speaker.
Follow the steps below to attach square grilles.
1. Use four #8 Phillips screws
(not included) to mount the adapter plate to the desired area in the ceiling.
2. Fit the speaker over the adapter plate.
3. Attach the grille to the adapter plate.
WARRANTY
Lifetime Limited Warranty
Episode® Accessories have a Lifetime Limited Warranty. This warranty includes parts and labor repairs on all components found to be defective in material or workmanship under normal conditions of use. This warranty shall not apply to products that have been abused, modified or disassembled. Products to be repaired under this warranty must be returned to a designated service center with an assigned return authorization (RA) number. Contact technical support at [email protected] for an RA number.
CONTACTING TECHNICAL SUPPORT
866.838.5052
© 2015 Episode ®
Rev: 151028-1505
advertisement
Related manuals
advertisement