Data Sheet
ADNS-5100/ADNS-5100-001
Solid-State Optical Mouse Lens
Data Sheet
Description
Ordering Information
The ADNS-5100 and ADNS-5100-001 Solid-State Optical
Mouse Lenses are designed for use with the ADNS-5XXX
series of Avago Technologies Optical Mouse Sensors.
The optical system is completed with the illumination
subsystem provided by the ADNS-5200 LED Assembly
Clip and the HLMP-ED80-XX000 LED. Together with the
LED, the ADNS-5100 and ADNS-5100-001 provides the
directed illumination and optical imaging necessary for
proper operation of the Optical Mouse Sensor. The lenses
are precision molded optical components and should
be handled with care to avoid scratching of the optical
surfaces.
Specify Part Number as follows:
Outline Drawings Including Markings and Logos
ADNS-5100
Figure 1. ADNS-5100 Solid State Optical Mouse Round Lens outline drawing and detail
Flange
Part Number
Material
Round
ADNS-5100
Polycarbonate or
Polystyrene HH30
Trim
ADNS-5100-001
Polycarbonate or
Polystyrene HH30
Outline Drawings Including Markings and Logos
ADNS-5100-001
Figure 2. ADNS-5100-001 Solid State Optical Mouse Trim Lens outline drawing and detail
Mechanical Assemble Requirements
All specifications reference Figure 3, Optical System Assembly Diagram
Symbol
Min.
Typical
Max.
Units
Distance from Object Surface to
Lens Reference Plane
A
2.3
2.4
2.5
mm
Distance from Mouse Sensor
Lid contact with lens Surface to
Object Surface
B
7.38
Conditions
mm
Sensor lid must be in contact
with lens housing surface
Figure 3. Optical System Assembly Diagram
Lens Design Optical Performance Specifications
All specifications are based on the Mechanical Assembly Requirements.
Numerical Aperture
Symbol
Min.
Typical
Max.
NA
0.1
0.13
0.16
Units
Magnification
1.25
Design Wavelength
639
nm
Object to Image Distance
8.83
mm
Lens Material*Index of Refraction
N
Depth of Field
DOF
Die Coverage Radius
1.580
1.582
Conditions
Image at nominal location
l = 639nm
1.5840
±0.5
mm
0.6
mm
*Lens material is polycarbonate or polystyrene HH30, therefore, cyanoacrylate based adhesives should not be used
as they will cause lens material deformation.
Mounting Instructions for the ADNS-5100 Lens to the Base Plate
An IGES format drawing file with design specifications for mouse base plate features is available.
Note :- Stand-off of the base plate shall not be larger than 5mm as lens surface 7 size is 5.60mm.”
Figure 4. Illustration of base plate mounting features
These features are useful in maintaining proper positioning and alignment of the ADNS-5100 when used with the
Avago Technologies Optical Mouse Sensor. This file can be obtained by contacting your local Avago Technologies
sales representative.
For product information and a complete list of distributors, please go to our web site: www.avagotech.com
Avago, Avago Technologies, and the A logo are trademarks of Avago Technologies, Limited in the United States and other countries.
Data subject to change. Copyright © 2007 Avago Technologies Limited. All rights reserved. Obsoletes AV01-0086EN
AV02-0115EN - July 31, 2007
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising