FAQ Can the Power Cables on Alarmnet IP Cameras be Extended?

FAQ Can the Power Cables on Alarmnet IP Cameras be Extended?
FAQ
Can the Power Cables on Alarmnet IP Cameras be Extended?
IPCAM-WO
The power cable on the IPCAM-WO is approved for extension to a distance of up to 183 feet (56 meters) using a
MINIMUM of 22 gauge twisted/untwisted wire and using the +12VDC 1A transformer supplied with the camera.
IPCAM-WI, IPCAM-WI2, IPCAM-PT
The power cable on the IPCAM-WI, IPCAM-PT, IPCAM-WI2, and IPCAM-WI2B is approved for extension
ONLY BY THE USE of the extension cables listed below:
IPCAM-WI, IPCAM-PT: Can extend the power cable using no more than ONE extension cable (P/N IPCAM-EXT)
which will provide an extension of nine foot. Use of the extension cable coupled with the supplied transformer will
provide a total length of fifteen feet. Any other method of extension is not approved.
IPCAM-WI2: Can extend the power cable using no more than ONE extension cable (P/N IPCAM-WI2EXT) which
will provide an extension of ten foot. Use of the extension cable coupled with the supplied transformer will provide
a total length of fourteen feet. Any other method of extension is not approved.
*IPCAM-WI2EXT is a white extension cable to match the white housing of the IPCAM-WI2.
IPCAM-WI2B: Can extend the power cable using no more than ONE extension cable (P/N IPCAM-WI2BEXT)
which will provide an extension of ten foot. Use of the extension cable coupled with the supplied transformer will
provide a total length of fourteen feet. Any other method of extension is not approved.
*IPCAM-WI2BEXT is a black extension cable to match the black housing of the IPCAM-WI2B.
-1-
Updated: 1/14/13
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising