Dolphin 6110 Regulatory Sheet

Dolphin 6110 Regulatory Sheet
REG-6110 Rev H
Dolphin™ 6110 Mobile Computer
Approvals by Country
Refer to the Honeywell compliance center at www.honeywellaidc.com/compliance to review and download any publicly available documentation pertaining to the certification of this product in a given country.
Dolphin RF Terminal—802.11a/b/g/n and Bluetooth
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. Our company is not responsible for any radio or television interference caused by unauthorized modifications of this
equipment or the substitution or attachment of connecting cables and equipment other than those specified by our company. The correction is the responsibility of the user. Use only shielded data cables with this system.
In accordance with FCC 15.21, changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
!
This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. To maintain compliance with FCC RF exposure guidelines for body-worn operation, do not use
accessories that contain metallic components.
CAUTION! Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment.
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. NII frequency band 5150-5250 MHz is restricted to indoor use only.
Canadian Compliance
This radio transmitter has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included
in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Cet appareil numérique de la Classe B est conforme à la norme NMB-003 du Canada.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
R&TTE Compliance Statement—802.11a/b/g/n and Bluetooth
The CE marking indicates compliance with the following directives:
• 1995/5/EC R&TTE
• 2011/65/EU RoHS (Recast)
In addition, this product complies to 2014/35/EU Low Voltage Directive when supplied with the recommended power supply.
European Contact:
Hand Held Products Europe B.V.
Lagelandseweg 70,
6545CG Nijmegen
The Netherlands
The equipment is intended for use throughout the European Community; PAN European Frequency Range: 2.402–2.480 GHz.
Restrictions for use in France are as follows:
•
•
Indoor use: Maximum power (EIRP*) of 100 mW for the entire 2.400–2.4835 GHz
Outdoor use: Maximum power (EIRP*) of 100 mW for the 2.400–2.454 GHz band & maximum power (EIRP*) of 10 mW for the 2.454–2.483 MGHz band.
Frequency band 5180-5320 MHz is restricted to indoor use only.
Product Environmental Information
Refer to www.honeywellaidc.com/environmental for the RoHS / REACH / WEEE information.
USA, Canada NRTL Statement
UL and C-UL listed: UL60950-1 2nd Edition and CSA C22.2 No. 60950-1-07 2nd Edition.
CB Scheme
Plan OC (organismes de certification)
Certified to CB Scheme IEC 60950-1, Second Edition.
Certifié CB CEI 60950-1, deuxième édition.
LED Safety Statement
Norme de sécurité sur les DEL
LEDs have been tested and classified as “Exempt Risk Group” to the standard IEC62471:2006.
Les DEL ont été testées et classées en tant que « GROUPE DE RISQUE EXEMPT » par rapport à la norme : IEC
62471:2006.
Laser Safety Statement
Déclaration de sécurité relative au laser
激光安全声明
鐳射安全聲明
If the following label is attached to your product, it
indicates the product contains a laser:
Si l’étiquette suivante est apposée à votre produit, cela
signifie que le produit contient un laser:
如果您的产品附有以下标签,说明产品具有激光功能:
若產品上貼有下列之標籤,即表示該
產品具有雷射功能:
This device has been tested in accordance with and
complies with IEC60825-1 ed2.0 and 21 CFR 1040.10
and 1040.11, except for deviations pursuant to Laser
Notice No. 50, dated June 24, 2007.
Cet appareil a été testé et reconnu conforme aux
normes IEC60825-1 ed2.0 et 21 CFR 1040.10 et
1040.11sauf pour les dérogations en accord avec l'avis
de conformité sur les lasers No. 50, en date du 24 juin
2007.
LASER LIGHT, DO NOT STARE INTO BEAM, CLASS 2
LASER PRODUCT, 1.0 mW MAX OUTPUT: 650nM.
Caution - use of controls or adjustments or performance
of procedures other than those specified herein may
result in hazardous radiation exposure.
LUMIÈRE LASER, NE PAS REGARDER
DIRECTEMENT DANS LE FAISCEAU, PRODUIT
LASER DE CLASSE 2, SORTIE MAX. DE 1,0 MW: 650
nm.
此设备已经过测试,符合 IEC60825-1 ed2.0 以及 21
CFR 1040.10 和 1040.11 标准,2007 年 6 月 24 日颁布
的第 50 号激光通告所规定的偏离除外。
激光辐射,不可凝视光束, 2 类激光产品,最大输出为
1.0 mW:650nM。
如果使用了用户文档范围之外的操作步骤控制或调整或
执行,可能会导致危险的辐射暴露。
此裝置已經過測試,符合 IEC60825-1 ed2.0 以及 21
CFR 1040.10 與 1040.11 標準,但 2007 年 6 月 24 日發
佈的第 50 號鐳射通告中所述的偏差不在此限。
鐳射光, 請勿直視鐳射光束, 等級 2 鐳射產品,1.0mW
最大輸出功率:650nM。
若使用的控制、調整或執行等程序並非依照使用者文件
中所指示,可能會發生危險,導致輻射曝露。
Mise en garde – l’utilisation de contrôles ou
d’ajustements ou de performance de procédures autres
que ceux spécifiées dans la présente peut provoquer
une exposition dangereuse au rayonnement.
Warning! To prevent possible hearing damage, do not listen at high volume levels for long periods.
Avertissement : A pleine puissance, l’écoute prolongée peut endommager l’audition de l’utilisateur.
REG-6110 Rev H
Dealer License - Republic of Singapore
( 经销商许可证 - 新加坡共和国 )
UAE
If the following label is attached to your product, the
product meets Taiwan agency approval:
TRA
Registered No:
ER0119114/13
Dealer No:
DA0052379/10
Complies with
IDA Standards
DA104404
If the following label is attached to your product, the
product meets Russia, Kazakstan and Belarus agency
approval:
BSMI Standard: CNS13438, CNS13436
依據標準 : CNS13438.CN13436
依據標準 : 低功率射頻電機技術規範 :LP0002 NCC standard:Low power frequency electric machineries technical standard:LP0002
根據交通部低功率管理辦法規定 : 第十二條 經型式認證合格之低功率射頻電機, 非經許可 , 公司 ,
商號或消費者均不得擅自變更頻率 , 加大功率或變更原設計之特性及功能。
第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通信 ; 經發現有干擾現象時 , 應立即停用 ,
並改善至無干擾時方得繼續使用。
前項合法通信 , 指依電信規定作業之無線電信。低功率射頻電機須忍受合法通信或工業 ,
科學及醫療用電波輻射性電機設備之干擾。
Informações ANATEL
Este produto está homologado pela Anatel, de acordo com os procedimentos regulamentados pela Resolução No. 242/2000 e nº 323/2002.
Agencia Nacional de Telecomunicacoes
01066-14-06583
Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência a sistemas operando em caráter primário.
Para maiores informações, consulte o site da ANATEL - www.anatel.gov.br.
产品中有害物质的名称及含量 (Names and Content of Hazardous Substances in the Product)
部件名称 (Parts Name)
有害物质 (Hazardous Substance)
铅 (Pb)
汞 (Hg)
镉 (Cd)
六价铬 (Cr6+)
多溴联苯 (PBB)
多溴二苯醚 (PBDE)
x
o
o
o
o
o
印刷电路部件 (PCA)
x
o
o
o
o
o
外壳 (Housing)
x
o
o
o
o
o
连接线 (Cable)
x
o
o
o
o
o
扫描模块 (Scanner Module)
本表格依据 SJ/T 11364 的规定编制。 (The table is created in accordance to SJ/T 11364.)
o: 表示该有害物质在该部件所有均质材料中的含量均在 GB/T 26572 标准规定的限量要求以下。
(Indicates that this hazardous substance contained in all of the homogeneous materials for this part is below the limit requirement in China’s GB/T 26572.)
x: 表示该有害物质至少在该部件的某一均质材料中的含量超出 GB/T 26572 标准规定的限量要求。
(Indicates that this hazardous substance contained in at least one of the homogeneous materials for this part is above the limit requirement in China’s GB/T 26572.)
Limited Warranty
For warranty information, go to www.honeywellaidc.com and click Resources > Warranty.
Patents
For patent information, see www.hsmpats.com.
User Documentation
For the user guide and other documentation, go to www.honeywellaidc.com.
Manufacturer Contact information:
Honeywell International Inc.
Honeywell Sensing & Productivity Solutions
9680 Old Bailes Road
Fort Mill, SC 29707 USA
REG-6110 Rev H
5/16
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising