HDMI® Over IP Receiver for ST12MHDLAN

HDMI® Over IP Receiver for ST12MHDLAN
HDMI® Over IP Receiver for ST12MHDLAN
ST12MHDLANRX
*actual product may vary from photos
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com
PT: Guia do usuário - pt.startech.com
For the most up-to-date information, please visit: www.startech.com
Manual Revision: 05/08/2017
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and do not
represent an endorsement of a product or service by StarTech.com, or an endorsement of the
product(s) to which this manual applies by the third-party company in question. Regardless
of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby
acknowledges that all trademarks, registered trademarks, service marks, and other protected
names and/or symbols contained in this manual and related documents are the property of
their respective holders.
Instruction Manual
Table of Contents
Introduction.......................................................................................................... 1
Packaging Contents.................................................................................................................................. 1
System Requirements............................................................................................................................... 1
ST12MHDLANRX Receiver Unit............................................................................................................. 2
ST12MHDLAN HDMI Extender Kit........................................................................................................ 2
Installation............................................................................................................. 3
Preparing Your Site.................................................................................................................................... 3
Hardware Installation Using Gigabit LAN Network....................................................................... 3
Hardware Reset Procedure..................................................................................................................... 4
EDID Copy..................................................................................................................................................... 4
Factory Default Setting............................................................................................................................ 5
Specifications....................................................................................................... 5
Technical Support............................................................................................... 6
Warranty Information........................................................................................ 6
Instruction Manual
i
Introduction
Packaging Contents
• 1x HDMI over IP receiver
• 1x foot pad set
• 1x universal power adapter (NA / EU / UK / AU)
• 1x mounting bracket
• 1x instruction manual
System Requirements
• 1 x HDMI® over IP Transmitter Unit
• 1 x HDMI® over IP Receiver Unit
• HDMI® enabled display device(s) One for each Receiver (i.e. television, projector)
• Available AC electrical outlet for transmitter, receiver and optional repeaters
• HDMI® cable for each display
Instruction Manual
1
ST12MHDLANRX Receiver Unit
Front
Rear
6
1
2
3
1
2
4
3
1. F2 (Used during EDID Copy
procedure)
1. Power Jack
2. F1 (Used during factory
default setting)
3. Reset Button
3. Dip Rotary Switch (Used to
pair Transmitter to Receiver)
5. Video Out
5
2. Network Status LED
4. LAN Port (RJ-45)
6. Link OK POWER LED
ST12MHDLAN HDMI Extender Kit
(Sold Seperately)
Transmitter
Front
Rear
6
1
2
3
1
2
3
4
5
1. F2 (Not Active)
1. Power Jack
2. F1 (Used during factory
default setting)
2. Network Status LED
3. Dip Rotary Switch (Used to
pair Transmitter to Receiver)
4. LAN Port (RJ-45)
3. Reset Button
5. Video In
6. Link OK POWER LED
NOTE: 1 Receiver Unit included with ST12MHDLAN HDMI Extender Kit
Instruction Manual
2
Installation
Preparing Your Site
NOTE: This device will only work with the ST12MHDLAN HDMI® Extender kit. Please
review site preparation steps from the ST12MHDLAN manual prior to installing
additional Receivers. The ST12MHDLAN HDMI® extender kit can use a Gigabit LAN
Network to extend the signal. Most Gigabit Network portals have a cable length
restriction of 330 ft. (100m). Refer to the manufacturer of the equipment to determine
the length restriction and ensure the Transmitter Unit, and Receiver Unit(s) are all
within the restricted range of the nearest network portal.
1. Determine where the Receiver/Display will be installed in relation to the
ST12MHDLAN HDMI® Extender kit (sold separately) and place/mount the
display appropriately.
2. (Optional) If using additional receiver unit(s) (sold separately), determine where
the remote display(s) will be located in relation to this receiver/display and place/
mount the display(s) appropriately.
NOTE: Ensure the Receiver Unit(s) are situated near an available AC electrical outlet.
Make sure all devices are turned off before beginning installation.
Hardware Installation Using Gigabit LAN Network
NOTE: This device will only work with the ST12MHDLAN HDMI® Extender kit. Please
review Hardware Installation Using Gigabit LAN Network steps from the ST12MHDLAN
manual prior to installing additional Receivers.
1. Install Receiver Unit(s)
a) Position the Receiver Unit(s) near the video display (i.e. television, projector).
b) Connect an HDMI® cable from the display Input to the “Video Out” port on the
Receiver Unit.
c) Connect the provided Receiver Unit power supply.
d) (Optional) If using additional ST12MHDLANRX Receivers (sold separately), repeat
steps for each additional Receiver.
NOTE: The “Dip Rotary Switch” on the Extender and each Receiver connected to the
network must be set in the same position for the devices to communicate.
Instruction Manual
3
2. Connect the devices to a Gigabit LAN Network
a) Connect an RJ-45 terminated Cat5e/6 Ethernet cable to the “LAN Port” (RJ-45
Connector) on the Transmitter unit, and all receiver units.
NOTE: If you are using surface cabling, ensure you have enough Category 5e/6
unshielded twisted pair (UTP) network cabling to connect the Transmitter Unit to the
Gigabit LAN hub, router, or switch.
OR
If you are using premises cabling, ensure that the Category 5e/6 unshielded twisted
pair (UTP) network cabling between the Transmitter and Gigabit LAN hub, router,
or switch has been properly terminated in a wall outlet in each location and there is
a patch cable long enough to connect the Network portal and Transmitter Unit to
their respective outlets.
b) Connect the other end of the Cat5e/6 cable run to a Gigabit LAN hub, router
or switch.
c) (Optional) When adding additional Receiver Units (ST12MHDLANRX – Sold separately), a run of Cat 5e/6 cable will be required from each device to the Gigabit LAN hub, router or switch.
3. Your source video image will now appear on the Receiver unit(s) attached
video display.
Hardware Reset Procedure
NOTE: If video signal does not appear on the display a hardware reset can be
performed on the Transmitter Unit, or individual Receiver Units.
1. Press the reset button on the device using a pin point tool, such as a ballpoint pen
or a bent paper clip.
EDID Copy
EDID allows the video source to output the most ideal signal to the video display. The
“EDID Copy” function on the ST12MHDLANRX ensures that EDID is still active through
the Ethernet extender.
NOTE: If you using multiple receivers the EDID can only be copied from one unit, the
signal customized for that display will be applied to all displays connected through
additional receivers.
1. Disconnect the power cable from the Receiver.
2. Hold down the F2 button
3. Reconnect the Power while holding down the F2 button
4. Release F2 button after the power has been reconnected for 12 seconds (the
Network Status LED flashes yellow), EDID is now active through the
Ethernet extender.
Instruction Manual
4
Factory Default Setting
1. Disconnect the power cable from the Transmitter/Receiver.
2. Hold down the F1 button
3. Reconnect the Power while holding down the F1 button
4. Release F1 button after the power has been reconnected for 17 seconds (the Link
OK POWER LED flashes green and blue)
5. Reconnect the Power again.
Specifications
Maximum Digital Resolutions
1920x1200 @60Hz
Supported Resolutions
1920 x 1200 (1080p)
Wide Screen Supported
Yes
Audio Specifications
Stereo Sound
Interface
HDMI®
Cabling
Cat 5e UTP or better
Audio
Yes
Rack-Mountable
Yes
Daisy-Chain
Yes
1x HDMI® (19 pin)
Receiver Connectors
1x RJ-45
Power Adapter Input Voltage
100~240V
Power Adapter Input Current
0.6 A
Power Adapter Output Voltage
DC 12V
Power Adapter Output Current
1.5 A
Center Tip Polarity
Positive
Plug Type
M
Instruction Manual
5
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commitment to
provide industry-leading solutions. If you ever need help with your product, visit
www.startech.com/support and access our comprehensive selection of online tools,
documentation, and downloads.
For the latest drivers/software, please visit www.startech.com/downloads
Warranty Information
This product is backed by a two year warranty.
In addition, StarTech.com warrants its products against defects in materials
and workmanship for the periods noted, following the initial date of purchase.
During this period, the products may be returned for repair, or replacement with
equivalent products at our discretion. The warranty covers parts and labor costs only.
StarTech.com does not warrant its products from defects or damages arising from
misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their
officers, directors, employees or agents) for any damages (whether direct or indirect,
special, punitive, incidental, consequential, or otherwise), loss of profits, loss of business,
or any pecuniary loss, arising out of or related to the use of the product exceed the
actual price paid for the product. Some states do not allow the exclusion or limitation
of incidental or consequential damages. If such laws apply, the limitations or exclusions
contained in this statement may not apply to you.
Instruction Manual
6
Hard-to-find made easy. At StarTech.com, that isn’t a slogan. It’s a promise.
StarTech.com is your one-stop source for every connectivity part you need. From
the latest technology to legacy products — and all the parts that bridge the old and
new — we can help you find the parts that connect your solutions.
We make it easy to locate the parts, and we quickly deliver them wherever they need
to go. Just talk to one of our tech advisors or visit our website. You’ll be connected to
the products you need in no time.
Visit www.startech.com for complete information on all StarTech.com products and
to access exclusive resources and time-saving tools.
StarTech.com is an ISO 9001 Registered manufacturer of connectivity and technology
parts. StarTech.com was founded in 1985 and has operations in the United States,
Canada, the United Kingdom and Taiwan servicing a worldwide market.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising