SureCross RS-485 to USB Adapter Cable

SureCross RS-485 to USB Adapter Cable
SureCross RS-485 to USB Adapter Cable
An adapter cable used to connect a SureCross device to a Windows PC
• Connects a SureCross Gateway or MultiHop Radio to a Windows PC USB port
• Cable BWA-HW-006 supplies power for one DX80 Gateway or one MultiHop Radio
operating at 250 mW
• Cable BWA-UCT-900 supplies power for one DX80 Gateway or one MultiHop Radio operating at 1 Watt
• Supports baud rates of 9600, 19200, and 38400
• Converts USB to RS-485 (2-wire) with a Euro-style connector
• Supports Windows XP and Vista
• Download the User Configuration Tool or MultiHop Configuration Tool software free
from Banner Engineering's Wireless I/O Products website
The BWA-UCT-900 is shown.
Do not use BWA-HW-006 to connect a Performance Gateway or MultiHop Radio operating in 1 Watt mode. Always configure the Performance and MultiHop models to operate in 250 mW mode before connecting them to your computer to avoid damaging your USB
port.
To supply power to 1 Watt radios during configuration, use cable BWA-UCT-900.
When plugging this cable into your computer for the first time, give the cable one to two minutes to check your computer for the proper
driver, download the driver, then install it. Plug the cable into your Gateway. The cable should then supply enough power to the Gateway
to configure the device.
For additional information, the most recent version of all documentation, and a complete list of accessories, refer to Banner Engineering's
website, www.bannerengineering.com/surecross.
Models
Adapter
Length
BWA-HW-006
RS-485 to USB
BWA-UCT-900
RS-485 to USB, with wall plug to power 1 Watt radios during configuration
1 meter
To be used with the DX80...C models, these adapter cables requires cable model MQDMC-401.
4-pin Euro-Style Connection (Female)
Wire No.
2
1
3
4
Wire Color
DX80 Wiring
DX80...C Wiring
1
Brown
10 to 30V dc
V+
2
White
RS485 / D1 / B / +
Tx
3
Blue
dc common (GND)
V-
4
Black
RS485 / D0 / A / –
Rx
Connecting dc power to the communication pins will cause permanent damage.
P/N 140377 Rev. B
11/5/2012
0 140377
0
SureCross RS-485 to USB Adapter Cable
Specifications
Input Power
BWA-HW-006: 5V dc from USB port
Current
BWA-HW-006: Less than 400 mA at the PC, single
Banner Gateway or Data Radio device (not intended to
power multiple Banner devices)
Operating Parameters
Temperature: –40 to +80°C
Humidity: Up to 95% Non-condensing
RS-485
2-wire; 9.6k, 19.2k, or 38.4k; 8 data bits; 1 stop bit; no
parity
Connector: Euro-style connector compatible with Banner wireless Gateway and Data Radio devices, 10V dc
power output
Banner Compatible Devices
DX80G*, DR9M, DR2M models.
(Cable BWA-HW-006 will not power a MultiHop radio in
1 Watt mode. Use cable BWA-UCT-900 to supply power to 1 Watt radios. To use cable BWA-HW-006 with a
MultiHop radio, set the radio to operate at 250 mW.)
USB
Connector: USB type A plug
Standard: 2.0
Length
1 meter (This cable can be extended up to 30 meters.)
Warnings
The manufacturer does not take responsibility for the violation of any warning listed in this document.
Make no modifications to this product. Any modifications to this product not expressly approved by Banner Engineering could void the
user’s authority to operate the product. Contact the Factory for more information.
All specifications published in this document are subject to change. Banner reserves the right to modify the specifications of products without notice. Banner Engineering reserves the right to update or change documentation at any time. For the most recent version of
any documentation, refer to our website: www.bannerengineering.com. © 2006-2010 Banner Engineering Corp. All rights reserved.
Banner Engineering Corp Limited Warranty
Banner Engineering Corp. warrants its products to be free from defects in material and workmanship for one year following the date of
shipment. Banner Engineering Corp. will repair or replace, free of charge, any product of its manufacture which, at the time it is returned
to the factory, is found to have been defective during the warranty period. This warranty does not cover damage or liability for misuse,
abuse, or the improper application or installation of the Banner product.
THIS LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES WHETHER EXPRESS OR IMPLIED (INCLUDING, WITHOUT LIMITATION, ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE), AND
WHETHER ARISING UNDER COURSE OF PERFORMANCE, COURSE OF DEALING OR TRADE USAGE.
This Warranty is exclusive and limited to repair or, at the discretion of Banner Engineering Corp., replacement. IN NO EVENT SHALL
BANNER ENGINEERING CORP. BE LIABLE TO BUYER OR ANY OTHER PERSON OR ENTITY FOR ANY EXTRA COSTS, EXPENSES, LOSSES, LOSS OF PROFITS, OR ANY INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES RESULTING FROM ANY
PRODUCT DEFECT OR FROM THE USE OR INABILITY TO USE THE PRODUCT, WHETHER ARISING IN CONTRACT OR WARRANTY, STATUTE, TORT, STRICT LIABILITY, NEGLIGENCE, OR OTHERWISE.
Banner Engineering Corp. reserves the right to change, modify or improve the design of the product without assuming any obligations or
liabilities relating to any product previously manufactured by Banner Engineering Corp.
www.bannerengineering.com - tel: 763-544-3164
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising