Important safety and operational information Warnings

Important safety and operational information
Please read the following information before using the headset. Additional warnings may be present
on the product, packaging or in the user manual.
Warnings
• Using Bluetooth headset at high volume level and noisy background can potentially cause
hearing loose.
• The volume level of the Bluetooth® headset may vary, depending on your mobile phone.
Before using your headset for the first time, adjust the headset volume to the lowest, then
increase the volume gradually until you reach to an acceptable level.
• High levels of volume may result in hearing loss, avoid using the headset at high volume
continuously. If you experience ringing in your ears or muffled speech, consult your doctor
immediately and stop using the headset.
• Check local laws regarding use of a mobile phone and earpiece while driving. If you use the
earpiece while driving ensure your attention and focus remain on driving safely.
• Observe all signs and instructions that require an electrical device or RF radio product to
be switched off in designated areas, such as gas/refueling stations, hospitals, blasting
areas, potentially explosive atmospheres, or aircraft.
• For optimal performance, wear your headset and your
mobile phone on the same side of your body or within
line of sight and angle the headset so that it points
toward your mouth.
• For better performances, avoid the microphone
touching your jaw or face. The face will absorb some of
the transmission output power and reduce the range. It
also leads to possible noise in audio. Use hook or not to
have the microphone 1cm from your jaw.
Charge warnings
• For your first time use, please charge your headset for 3-4 hrs until the red indicator light
turns off.
• To maximize battery lifetime, it is recommended to recharge your headset to full capacity
only when the battery is low, since a battery has a life time of about 350 charging cycles.
• If you leave your headset battery empty for an extended period of time, it could excessively
discharge the battery. In this case, charge your headset for 3 hours or more until the battery
recovers and recharges completely. When you first charge the headset after prolonged
storage, it may take few minutes for the red indicator light to turn on.
• It is recommended to full charge your headset before you store it for long periods of time
without use.
• If your headset is fully charged, the red indicator light will not turn on when plugging into
the charger.
• Do not over charge your headset for more than 10 hours.
• The use of any other charger will automatically suspend the warranty. It is forbidden and
can be dangerous.
• Ensure that the voltage rating corresponds to the local mains or power supply you intend
to use.
• Optimal handling may not always be practical in real life. Deviations from the ideal are
acceptable but will lower the life expectancy of the battery to some degree.
Others warnings
• Do not drop or try to alter the shape of your headset.
• Do not expose your headset to liquid, moisture, fire, open flames and extreme
temperatures. The operating temperature range is -10°C to + 55°C(14°F to 131°F).
The storage temperature range is -20°C to + 60°C (-4°F to 140°F).
• Keep your headset away from dust and dirt.
• Do not try to disassemble your headset. Service and Maintenance can only be performed
by authorized dealers.
• Do not let children play with your headset, since it contains small parts that could become
detached and create a choking hazard. Keep all products, cords, and cables away from
children. As with all corded products, there is a danger of strangulation if a cord should
become wrapped around your neck.
• Install and use earbuds in accordance with the instructions provided. Do not force the
speaker and earbuds down the ear canal. If either becomes lodged in the ear canal, seek
medical attention immediately.
Certification and Safety approvals
This product is CE marked according to the provisions of the R&TTE Directive (99/5/EC).
We declare that this product is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC. For further information, please refer to website.
FCC/ Industry Canada Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference. (2) This device must accept
any interference received, including interference that may cause undesired operation.
In compliance with Industry Canada regulations, technical specifications have been
provided in a declaration of conformity. This does not imply that Industry Canada approved
the equipment.
Caution: Changes or modifications to this Bluetooth® headset not expressly approved by the
party responsible for compliance could void the user’s authority to operate it.
Bluetooth® is a trademark owned by Bluetooth SIG, Inc. and is used by the manufacturer
under license.
For more information, please visit our website : www.bluetrek.com
Note on environmental protection:
After the implementation of the European Directive 2002/96/EU in the national legal system, the following applies:
Electrical and electronic devices may not be disposed of with domestic waste. Consumers are obliged by law to
return electrical and electronic devices at the end of their service lives to the public collecting points set up for
this purpose or point of sale. Details to this are defined by the national law of the respective country. This symbol
on the product, the instruction manual or the package indicates that a product is subject to these regulations. By
recycling, reusing the materials or other forms of utilizing old devices, you are making an important contribution
to protecting our environment.

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project