Wireless Optical Desktop

Wireless Optical Desktop
Wireless Optical Desktop User Manual
CAN-2700W + CAN-901W
FEDERAL COMMUNICATIONS
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions : (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
CAUTION
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection. This equipment generates uses and can radiated radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in particular installation if this equipment
dose cause harmful interference to radio or television, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician of help.
Shielded interface cables must be used in order to comply with emission limits.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate equipment.
PACKAGE CONTENT
1. Wireless Keyboard
2. Rechargeable Wireless Optical Mouse
3. Mini Receiver
4. Charging Cable
5. AAA Battery x 2
6. AAA Ni-MH Rechargeable Battery x2
7 User Manual
SYSTEM REQUIREMENT
1. IBM-Compatible PC
2. Microsoft Windows
3. Available USB port
98SE/ME/2000/XP
INSTALL
Connect the Receiver to Your Computer
• Please insert the mini USB receiver / dongle into the available USB port.
Insert the batteries for mouse
• Press at the end of battery lid on the back side of the mouse to open.
• Insert 2 triple A rechargeable batteries into the battery tray. Please make sure that
the batteries were inserted in correct directions before closing the battery lid.
Insert the batteries for keyboard
• Press to open the battery lid on the back side of the keyboard.
•Insert the two AAA batteries into the battery tray. Please make sure that the batteries
were inserted in correct directions before closing the battery lid
Connection Setup
•Please press the LED/connect button on the Mini USB Receiver dongle.
* The LED will begin flashing after the connect button is being pressed.
• After the connect button of the receiver is pressed, simply press the connect button
on the keyboard.
• Then, press the connect button on the bottom surface of the mouse to establish the
wireless connection.
Test the mouse
•Please move the mouse around to test whether the wireless connection has been
established or not. If the receive signal LED on the receiver flashes, it means the
wireless connection has been established. If the receiving signal LED does not flash
or the mouse pointer on your monitor screen does not move, you need to repeat the
Connection Setup step again.
Charge the Mouse
Note: The wireless mouse is rechargeable. Please use only Ni-MH rechargeable
batteries for charging. Otherwise the device maybe severely damaged.
•For the first time use, please charge the mouse to its full power capacity (at least 8
hours). To recharge the device, please take out the charging cable that comes with the
package. Please follow the picture description shown below, and plug in the audio pin
of charging cable to the front female audio port of the mouse, then plug the USB
cable connector into an available USB port.
•When the charging cable is well connected, the charging process is begin. Under
charging mode, you may still use the mouse without interference. After charging for at
least 8 hours, the batteries have been fully charged, and you may unplug the charging
cable from the mouse to finish the charging process.
CAUTION
• For the first time use, please charge the mouse at minimum of eight(8) hours for
maximum performance.
• Please use only Ni-MH rechargeable batteries for charging purpose. Using
non-rechargeable batteries for charging purpose may severely damage the mouse.
• Please connect the Mini Receiver / adapter to the computer main frame to ensure the
best connection quality.
• If there is a delay for the mouse under normal use, it indicates that the mouse is
low in batteries, or the connection has been interrupted. At this moment, please charge
the mouse, or reconnect the device if necessary.
-- After each time you re-setup the Mini-Receiver, or replace the batteries of the
mouse, if the wireless connection is lost, please simply repeat Connection Setup step.
Battery Saving
The mouse has a battery saving feature, and the LED may be powered off
manually or automatically under following 2 conditions.
1. When the mouse is set to idle for 8 minutes (the time may vary depending on
the model), the device will be automatically switched off. To re-activate the
device, simply press on any mouse button to resume operation.
2. The mouse may also be switched off manually by pressing the red connect
button of the mouse for at least 3 seconds. To re-activate the device, simply
press the red connect button of the mouse again to resume operation.
NOTICE: If the mouse is been switched off manually, pressing any mouse button
will not re-activate the device. The operation is resumed if and only if the red connect
button of the mouse is pressed. If the mouse is been switched off automatically,
pressing on the red connect button will not resume operation, but to lose the
connection. Therefore, if the device is being switched off automatically, simply press
any mouse button to resume except the connect button.
Hot Key Definition of the Keyboard
BACK : Go back to the previous web page.
FORWARD : Go to the next web page.
FAVORITES : Open the "Favorites" group.
WEB/HOME : Start your default browser and link immediately to your Home
Web page.
MAIL : Start the default E-mail program.
PLAY/PAUSE : Play or pause the default media player.
PREVIOUS TRACK : Change to the previous media track of the default media
player.
NEXT TRACK : Change to the next media track of the default media player.
MEDIA : Start the music CD player, or Microsoft Windows Media Player
application.(#1)
VOLUME DOWN : Decrease the system volume.
VOLUME UP : Increase the system volume.
CALCULATOR : Start "CALCULATOR" program.
MY COMPUTER : Open "My Computer" window.
Hot Key Definition of the Mouse
*CAN-901W
Resolving Basic Problems
• If the mouse cursor is controlled by another device operated by a different
system in a multi-user environment, please unload the batteries and reinsert them
again, and simply repeat the Connection Setup step.
• A desk made of metal will negatively impact wireless optical mouse performance.
To achieve maximum performance, please do not use the mouse on shinning
platforms.
• If your devices do not work smoothly, you may try the following steps :
a. replace the old batteries with the new ones, or charged the mouse if and only if
the rechargeable batteries are inserted.
b. repeat Connection Setup step.
c. move wireless mouse closer to receiver.
"The equipment is to be supplied from an identified USB port complying with the requirements
of Limited Power Source"
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising