Installation Instructions for Cody 6" Canopy Mount

Installation Instructions for Cody 6" Canopy Mount
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
info@edgelighting.com
© 2009 Edge Lighting. All Rights Reserved.
Installation Instructions for
904-CPL-6-01
CPL-6-_
Cody 6" Canopy Mount Picture Light
IMPORTANT INFORMATION
- This product is ETL listed for indoor location
- This product is wall mounted only.
- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
- This instruction shows a typical installation.
SAVE THESE INSTRUCTIONS!
Install the Fixture
A
1: Rotate the Cody's head perpendicular to the arm making
sure the arm is completely inserted into the head. Tighten
the M3 set screw on the swivel connector with the provided
1.5mm Allen wrench to secure the head in place.
1
HEAD
1.5MM ALLEN
WRENCH
1
ARM
M3 SET SCREW
B
MOUNTING BRACKET
SWIVEL
CONNECTOR
NOTE: The Cody 6" canopy mount must be installed right
above the electrical box.
2: Hold the mounting bracket against the wall above the
electrical box. Level the mounting bracket and mark the
bracket holes on the wall.
2
3
ANCHOR
3: Tap the anchors onto the marked points into the wall up to
the threaded portion with a hammer.
4: Screw the threaded portion of the anchors in with the a
Phillips screwdriver.
WALL
4
ELECTRICAL
BOX
1
C
5: Connect the white LED power supply wire to the neutral
power wire with a wire nut.
6
7
6: Connect the black LED power supply wire to the hot power
wire with a wire nut.
7: Place the LED power supply and all wire connections inside
the electrical box.
5
D
WIRE NUT
LED POWER SUPPLY
ELECTRICAL BOX
ELECTRICAL BOX
CROSSBAR
ASSEMBLY
#8-32 SCREW
8
8
8: Mount the crossbar assembly to the electrical box holes with
the provided #8-32 screws.
E
POWER WIRE
9: Line up the mounting bracket holes with the anchors and
secure the fixture to the anchors with the two #8 screws
provided.
ANCHOR
MOUNTING
BRACKET
9
#8 SCREW
F
ELECTRICAL
BOX
ARM
M4 SET
SCREW
MOUNTING
BRACKET
2MM ALLEN WRENCH
10
10: To adjust the Cody height, loosen the two M4 set screw on
the mounting bracket with the provided 2mm Allen wrench.
Adjust the Cody by sliding it up or down. When the desired
height is achieved tighten the two M4 set screws with the
2mm Allen wrench.
2
G
11: Connect each low voltage LED power supply wire (red
wire) to one fixture wire with a wire nut.
12: Place the excess wires and wire nuts inside the electrical
box.
13: Line up the canopy cut out edge with the fixture wires.
Place the canopy onto the electrical box and tighten the
thumb nut to the crossbar assembly nipple.
H
CUTOUT
MOUNTING BRACKET SLOT
COVER
THUMB
NUT
11
11
13
14
12
FRAME CABLE
14: Hang the frame cable into the mounting bracket slot.
I
FIXTURE HEAD
15: Rotate the fixture head to properly wash the picture with
light.
NOTE: The Cody 6" contains 6 watt integrated LED lamps. These
lamps are rated for 50,000 hours.
15
PICTURE
3
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising