EX-9510/A

EX-9510/A
EX-9510/A
Isolated RS-422/485 Repeater
Introduction
The EX-9510/A repeater boosts the RS-422/485 signals to extend the reach distance up to 4000 ft (1200m) and
increase the maximum number of connected nodes up to 128.
With a special circuitry, EX-9510/A is able to automatically detect the data flow and switch the direction of the data
lines accordingly.
“Auto baud rate detector” enables EX-9510/A to automatically configure RS-422(EX9510A)/485 signals to any baud
rate without external switch setting.
Build in Opto-isolations on EX-9510/A provides 3000VDC of isolation to protect the host computer from ground loops
and destructive voltage spikes on the RS-422(EX9510)/485 data lines.
EX-9510/A also offers internal surge-protection on the data lines. Internal high-speed transient suppressors on each data
line protect the module from dangerous voltages levels or spikes.
Features
Automatic internal RS-422(9010A)/485 bus supervision
No external flow control signals required for RS-485
Minimum 3000VDC isolation protection
Transient suppression on RS-485 data lines
Supported baud rate up to 115.2Kbps
Reach distance up to 4000 feet (1200m)
Reserved space for termination resistors (R8,R9)
Power and data flow indicator for troubleshooting
Power requirement: +10V to +30VDC
Mounts easily on DIN-rail or panel
Specifications:
Power requirement: Unregulated +10 to +30VDC with protection from power reversals
Case: ABS with captive mounting hardware
Accessories (Supplied): NYLON DIN-rail Mounting Adapter SECC Panel Mounting Bracket
Plug-in screw terminal wiring: Accepts AWG 1-#12 to #22 (0.5 to 2.5mm) wires
Supported baud rate (bps): 1200, 2400, 4800, 9600, 19.2K, 38.4K, 57.6K, 115.2K
Isolation voltage: 3000VDC
RS-422(EX9510)/RS-485 connector: plug-in screw terminal
Power consumption: 2.2W
Operating temperature: 0~70℃ (32~158℉)
Storage temperature: -25~85℃ (13~185℉)
Humidity: 5~95%, non-condensing
Power supply
EX series modules are designed to accept industry standard +24VDC unregulated power. Operation is guaranteed
when using any power supply between +10 and +30VDC.
Power ripples must be limited to 5V peak to peak while the voltage in all cases must be maintained between +10V and
+30VDC. All power supply specifications are referenced at module connector.
EX-9510 user’s manual
EX-9510/A
Isolated RS-422/485 Repeater
Block diagram
Isolation = 3000VDC
Data0+
Auto line
control
RS-485
Transiver
Auto line
control
Data0TX0+
TX0RX0+
RX0-
RS-485
Transiver
RS-422
Transiver
Data1+
Data1-
+Vs
+5V
Vs
GND
(+10V to +30VDC)
DC/DC
RS-422
Transiver
DC
DC
TX1+
TX1RX1+
RX1-
F
Connection
Dimensions
EX-9510/A user’s manual
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising