hunza pure led pond lite luminaires please retain the swing tag

HUNZA PURE LED POND LITE LUMINAIRES
PLEASE RETAIN THE SWING TAG ATTACHED TO THE FIXTURE
FOR FUTURE REFERENCE.
INSTALLATION INSTRUCTIONS
NOTE: THESE INSTRUCTIONS MUST NOT CONTRAVENE YOUR LOCAL ELECTRICAL
AUTHORITY REGULATIONS, WITH WHICH ALL INSTALLATIONS HERE IN MUST
COMPLY.
PLEASE KEEP INSTRUCTIONS FOR FUTURE REFERENCE.
Be sure when mounting the Pond Lite that any holes drilled in the pond do not perforate any
waterproofing membrane which may cause leaks. If drilling holes is not appropriate then use
a Pond Lite weighted version. Use the stainless steel screw and rawlplug supplied to mount
the fitting. The Pond Lite is supplied with a 3 metre cable which must be terminated using
heavy walled adhesive lined heat shrink outside the pond.
LED CHANGING
CAUTION: Make sure that the power to the luminaire is switched off before attempting to
change the LED.
LED Changing Sequence
When replacing gasket and lens, make sure there is no dirt or grit on the gasket. Dirt or grit
on the gasket may cause luminaire to leak.
Gasket and lens sequence
Place lens on top of lamp and put orange gasket on top of lens. Screw on lens ring.
Recommendation:
Run all low voltage cables in flexible conduit for extra protection. Use Hunza Cable Joint Kit
CJK#150. It is recommended that high quality lamps are used when replacing lamps. Do not
over tighten lens ring as this will make removal difficult and may cause lamp to break.
PLEASE NOTE - Pool Chemicals, hard water or salt water may damage the powder coated
finish. Stainless steel fittings should be used in these situations.
GLARE GUARD INSTALLATION
Carefully remove lens ring making sure not to drop the glass lens and cause damage to it,
keeping gasket in place. Hold body of luminaire tightly and screw Glare Guard ring onto light
luminaire. Still holding body of luminaire tightly rotate glare guard to desired position.
Stainless Steel Maintenance: To maintain the finish of 316 stainless steel it is recommended
to wash the luminaire with fresh water from time to time to stop salt and corrosive elements
building up. If tea staining appears, a commercially available stainless steel cleaner is
recommended to remove this. Electro polishing is recommended in this situation but the
fitting will still require regular maintenance. Even an electro polished stainless steel fixture
under an eave or roof will suffer from the build up of salt deposits as it will not be washed
away by rain.
PLEASE RETAIN THE SWING TAG ATTACHED TO THE FIXTURE
FOR FUTURE REFERENCE.
Note : If not using a HUNZA™ driver - you must select a suitable constant-current driver.
Decide what output is required in mA (350, 700, 1000), the LED requires a forward voltage
of 6 vdc.
Warning: Do not disconnect the LED luminaire from secondary side of the the driver
connected to the mains. Switch off mains FIRST then disconnect luminaire from the output
side of the driver.
Fixture wired in Series
Driver
Output
+
Fixture with Internal Driver Wired in Parallel
D
Transformer
12vac
output
D
D

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project