Keypad Wiring and Addressing

Keypad Wiring and Addressing
Keypad Wiring and Addressing
Keypad Wiring
1.
2.
3.
4.
Connect the Black keypad wire to Terminal 20 on the panel.
Connect the Yellow keypad wire to Terminal 21 on the panel.
Connect the Green keypad wire to Terminal 22 on the panel.
Connect the Red keypad wire to Terminal 23 on the panel.
Address Keypad
Setting OMNI-KP and OMNI-LCD keypad address
1. Power down keypad, power back up. Within 30 seconds press the [CODE] and
[STAY] keys at the same time.
2. Keypad display will show pulsing single digit, enter the address 1-8.
3. Press [*] key to exit.
4. Once all keypads are addressed power down entire system so it recognizes new
keypad addresses.
NOTE: During initial installation, the system reads the addresses of the connected
keypads and automatically maps those keypads to partition. Use [#] [0] command to
assign each keypad to the appropriate partition.
Setting XK-7LC keypad address
1. Set DIP Switches to address desired. Refer to Table 1.
2. Once all keypads are addressed power down entire system so it recognizes new
keypad addresses.
Address
1
2
3
4
5
6
7
8
1
OFF
ON
OFF
ON
OFF
ON
OFF
ON
Switch
2
OFF
OFF
ON
ON
OFF
OFF
ON
ON
3
OFF
OFF
OFF
OFF
ON
ON
ON
ON
Table 1
NOTE: During initial installation, the system reads the addresses of the connected
keypads and automatically maps those keypads to partition. Use [#] [0] command to
assign each keypad to the appropriate partition.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising