Smarthome SELECT Vstarcam Wireless HD IP Camera I/O Alarm

Smarthome SELECT Vstarcam Wireless HD IP Camera I/O Alarm
Smarthome SELECT Vstarcam Wireless HD IP Camera I/O Alarm Triggering Guide
When combined with the INSTEON I/O Linc, the user can have low voltage / contact closure devices
(pool valves, electric door strikes, garage doors and more) send an INSTEON command via the I/O Linc
to trigger the alarm function on the camera. Depending on settings, this alarm function can record video
to a MicroSD card, take a snapshot and send to email, sound an alarm, etc.
Also, when motion is captured organically through the camera itself, it will trigger the I/O Linc to send an
On command. This can be used to get text alerts, trigger an INSTEON-controlled lamp to turn on, etc. At
the end of motion, the I/O Linc will send an Off command.
Follow the steps below to connect the camera to the I/O Linc:
1. Wire two OUT terminals of camera to S and GND on I/O Linc
2. Wire two IN terminals of camera to N/O and C on I/O Linc
3. Setup I/O Linc
a. Momentary mode for about 1 second
b. On or Off closes Relay
c. Sensor DOES NOT trigger relay
d. Sensor sends OFF when closed
4. Setup camera
a. Enable motion detect alarm
b. Enable Extern Input Armed
c. Trigger: Closure
d. Enable I/O Linkage on Alarm
e. Output Level: Low
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising