Start-up Short instructions to accompany the operating instructions

Start-up Short instructions to accompany the operating instructions
Mover® XT / XT2 / XT4 / XT L
Start-up
Short instructions to accompany
the operating instructions
rerequisite: Parking brake applied; front wheel lowered;
P
towing vehicle uncoupled
❶
If present: Switch on battery cut-off switch; insert plug into safety socket
❷
❸
LED
1
2
3
witch on remote control and wait until LED 4 is permanently on in green
S
(Note: The remote control switches itself off if it is not used for one minute,
LED 4 flashes in green four times and an acoustic signal is heard 4 times. To
use the remote control again, switch it off and on again. After one hour without being used, see rear „Protecting the battery“)
4
Swivel in the Mover® XT
❹
Release parking brake
❺
piep
piep
Manoeuvre
to destination
❻
piep
piep
piep
Apply parking brake
❼
piep
piep
Swivel out the Mover® XT
❽
Switch remote control off
❾
piep
piep
⓫
Unplug plug from safety socket and plug into towing vehicle;
switch off battery cut-off switch if present
To continue driving: Couple to towing vehicle; wind up front wheel;
release handbrake
www.truma.com
piep
06/2014 • GB • F0
❿

LED
LED
1
2
3
4
Safety
No button pressed on remote control
for one minute.
Display
LED 4 flashes 4 times, and an acoustic
signal is heard 4 times. Then the
remote control switches itself off.
Remedy
Switch off remote control at slide
switch. Switch on remote control
again to continue using the Mover.
The safety plug is unplugged from
the socket with the remote control
switched on.
LED 4 flashes 4 times, together with
an acoustic signal. Then the remote
control switches itself off.
Switch off remote control at slide
switch. To continue using the Mover,
plug safety plug in again and switch
on remote control.
The battery is disconnected with the
remote control switched on.
LED 1 illuminates and LED 4 flashes 4
times, together with an acoustic signal. Then the remote control switches
itself off.
Switch off remote control at slide
switch. To continue using the Mover,
reconnect battery and switch on
remote control.
Problem with radio link while
manoeuvring.
LED 4 flashes 4 times, together with
an acoustic signal. Then the remote
control switches itself off.
Switch off remote control at slide
switch. For better reception quality,
move closer to the control unit. Avoid
sources of interference such as radio
signals reflecting from building walls
or other radio signals. Switch remote
control on again.
The remote control is switched off
with the motors swivelled in.
LED 2 flashes for one minute, together Switch on remote control again at the
slide switch and allow the motors to
with an acoustic signal. Then the
swivel out completely. Then switch the
remote control switches itself off.
remote control off.
The safety plug is unplugged with the
motors swivelled in and the remote
control switched on.
LEDs 2 and 4 flash for one minute,
together with an acoustic signal. Then
the remote control switches itself off.
Switch off remote control at slide
switch. Plug safety plug in again.
Switch on remote control again at
the slide switch and swivel out the
motors. Switch the remote control
off. The safety plug can now be
unplugged.
The battery is disconnected with the
motors swivelled in and the remote
control switched on.
LED 1 illuminates and LEDs 2 and 4
flash for one minute, together with
an acoustic signal. Then the remote
control switches itself off.
Switch off remote control at slide
switch. Re-connect the battery. Switch
remote control on again at the slide
switch. Swivel out the motors and
switch off the remote control.
LEDs 1 and 3 illuminate for one
minute, together with an acoustic
signal. Then the remote control
switches itself off.
Switch off remote control at slide
switch. Allow battery to recover and
recharge as soon as possible.
When the remote control is switched
on again, LED 4 flashes slowly ten
times, then flashes quickly four times
with an acoustic signal. Then the
remote control switches itself off.
Switch off remote control at slide
switch. Unplug safety plug and
plug in again or disconnect battery
and reconnect. Switch remote control
on again at the slide switch.
Warning
Low battery charge.
Protecting the battery
If the remote control is switched off
for longer than one hour, the control
unit goes into standby mode.
www.truma.com
06/2014 • GB • F0
Mover® XT / XT2 / XT4 / XT L
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising