EKG Multi-link Cable and Lead Wires

EKG Multi-link Cable and Lead Wires
EKG Multi-link Cable and Lead Wires
INSTRUMENT CONNECTOR
TRUNK CABLE
YOKE
ELECTROCARDIOGRAPH
LEADS SET
Specifications
Storage and transport environment: -5-+400C
Operating temperature: 0-+400C
Humidity
Operating/Storage/Transportation 0% to 80% non condensing Altitude
Hyperbaric Pressure 86kPa-106kPa
Biocompatibility: All patient contact materials are latex free and have been tested according to ISO 10993-5,ISO 10993-10.
Instrument Connectors
A variety of 15 pin D-subminiature connector and round type solutions are available in either metal or plastic connectors, overmolded housings and
straight or angled flex-reliefs. Connectors are surrounded by insert molded flex-reliefs to protect terminations and extend product life.
Trunk Cables
The multi-link and 2 meter (80 inch) trunk cable Shielded, low noise cable minimises microphonic noise and electrical interference. Flexreliefs at the
connector and cable yoke provide added durability and reduce conductor breakage. The cable is available in AHA or IEC nomenclature and colour coded
patient terminations. Lot numbers are included to indicate equipment compatibility and product traceability.
Patient end termination
Lead wires can be terminated to a variety of patient connectors to mate with adapters or industry standard electrode attachments. Shielded Lead wires
are jacketed in TPU and have colour coded flex reliefs. Lead wires can accommodate 4.7 k, 10k or 20k ohm resistors (SNAP grabber, banana and straight
pin only).
+44 (0) 844 809 4778 (24 Hr contact centre)
EKG Multi-link Cable and Lead Wires | 85
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising